|
|
3. Attach cable plug -1- . Make sure that the plug engages audibly. Removing and installing shield 4. Fit the side shield to the relevant side of the engine. To do this, insert and tighten the two M6 x 16 Torx screws -arrows- . → Tightening torque: 7.5 ftlb. 997110, 997111, 997120, 997121, 997310, 997311, 997320, 997321, 997410, 997411, 997430, 997431, WARNUNG Gefahr des Verlusts der Text-Bild-Zuordnung beim Ausdruck. Aus technischen Gründen kann derzeit nicht ausgeschlossen werden, dass trotz • Wird der Fehler nicht bemerkt, besteht die Gefahr, daß Arbeiten nicht korrekt • → Vergleichen Sie deshalb nach dem Druckvorgang unbedingt die Ausdrucke mit der WARNING Danger of losing text-figure correspondence when printing out. For technical reasons, it can currently not be ruled out that the correspondence • If the fault is not noticed, there is the danger that work will not be performed • → Therefore, always compare printouts with the screen display after printing them out. Correct Diagnostic system: reading out fault memory and activating systems Installing hydraulic valve for valve lift control 473 |