|
|
ENGINE 2.62 WARNING Never remove the pressure cap when the engine is warm or hot. If the pressure cap is to be removed, the engine NOTE: Always use Polaris premium antifreeze 60/40 premix. Bleed system at specified RPM or air will remain Filling and Bleeding Procedure If the cooling system should become low in the reservoir- 800 XCR Bleeding Procedure 1. Fill cooling system. Leave pressure cap off. 2. With engine running at specified idle speed, loosen 3. Continue adding antifreeze mixture to reservoir bottle 4. Close bleed screw and tighten securely. 5. Fill reservoir bottle until it is between the minimum and 6. Replace pressure cap. 7. Start engine and check for leaks. 440/500/600/700 Domestic Twins Bleeding Pro- 1. Fill cooling system . Leave pressure cap off. 2. With engine running at specified idle speed, loosen 3. Continue adding antifreeze mixture to reservoir until 4. Close bleed screw and tighten securely. 5. Fill reservoir bottle until coolant level is between the 6. Replace pressure cap. 7. Start engine and test for leaks. Bleed Screw 700/800 XCR Bleed Screw 500/600/700 Domestic Twins |