|
|
– Loosen the catches -1- on both sides in the direction of the -arrow A-. – Remove the rain sensor trim -2-. -arrow A-. – Fold out the Distance Regulation Control Module - J428- -3- in the direction of the -arrow B-. – Remove the Distance Regulation Control Module - J428- -3- from the adapter frame -2-. Installing the following: ⇒ “6.3 Adaptive Cruise Control, Calibrating”, page 45 . 6.3 Adaptive Cruise Control, Calibrating Conditions brated during the following conditions: ♦ Distance Regulation Control Module - J428- was removed and installed or replaced. ♦ Bumping into the Distance Regulation Control Module - J428- when not cautiously assembling the front bumper cover. ♦ Damage to the front bumper cover due to an accident or something similar. ♦ The front bumper carrier was remove and installed or re‐ placed. ♦ Rear axle toe was adjusted. Control Module - J428- causes the ACC/Front Assist functions to remain switched off. This will show the following message in the Instrument Cluster - KX2- : ACC/Front Assist not availa- ble . A limited sensor view due to a dirty sensor or inclement weather conditions such as heavy rain, snowfall or iced-over sensor cau‐ ses the ACC/Front Assist functions to be temporarily unavailable. This is indicated by the following message in the Instrument Clus‐ ter - KX2- : ACC/Front Assist: No sensor view . – Calibrate the adaptive cruise control. Refer to ⇒ Suspension, Wheels, Steering; Rep. Gr. 44 ; Adaptive Cruise Control (ACC); Adaptive Cruise Control (ACC), Calibrating . |