|
|
Content .. 1579 1580 1581 1582 ..
NEXT (i) Start the engine and warm it up. (j) Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern. (k) Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness. (l) Input the DTC: P050A. (m) Check the DTC judgment result. Result RESULT PROCEED TO NORMAL (DTC is not output) A ABNORMAL (DTC P050A is output) B B GO TO STEP 15 A CHECK FOR INTERMITTENT PROBLEMS 15. CHECK HARNESS AND CONNECTOR (MASS AIR FLOW METER CONNECTOR
. HINT: Repair any problems. 16. CHECK WHETHER DTC OUTPUT RECURS (DTC P050A) NOTICE: For this operation, the engine must be cold (the same level as the engine coolant temperature recorded in the freeze frame data). (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Clear DTCs
. (e) Turn the ignition switch off and wait for at least 30 seconds. (f) Turn the ignition switch to ON and turn the Techstream on. (g) Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Coolant Temp. 3UR-FBE ENGINE CONTROL SYSTEM: SFI SYSTEM: P050A; Cold... |