|
|
Content .. 2356 2357 2358 2359 ..
6E–468 6VE1 3.5 ENGINE DRIVEABILITY AND EMISSIONS Rough, Unstable, or Incorrect Idle, Stalling Symptom (Cont'd) Step No Yes Value(s) Action 19 Using a Tech 2, monitor the throttle position 1 and 2 Is the TP angle at the specified value and steady? 8 ∼ 10% Go to Step 20 Refer to DTC for further diagnosis 20 1. Check the positive crankcase ventilation (PCV) valve for proper operation. Refer to Crankcase Ventilation System. 2. If a problem is found, repair as necessary. Was a problem found? — Verify repair Go to Step 21 21 1. Check the transmission range switch circuit. Use a Tech 2 and be sure the Tech 2 indicates that the 2. If a problem is found, diagnose and repair the transmission range switch as necessary (refer to Was a problem found? — Verify repair Go to Step 22 22 1. Check for the following engine mechanical items. Refer to Engine Mechanical for diagnosis procedures: D Low compression D Sticking or leaking valves D Worn camshaft lobe(s) D Camshaft drive belt slipped or stripped D Incorrect valve timing D Worn rocker arms D Broken valve springs 2. If a problem is found, repair as necessary. Was a problem found? — Verify repair Go to Step 23 23 1. Check for faulty motor mounts. Refer to Engine Mechanical for inspection of mounts. 2. If a problem is found, repair as necessary. Was a problem found? — Verify repair Go to Step 24 24 1. Review all diagnostic procedures within this table. malfunctions have been found, review/inspect the D Visual/physical inspection D Tech 2 data D Freeze Frame data/Failure Records buffer D All electrical connections within a suspected 3. If a problem is found, repair as necessary. Was a problem found? — Verify repair Contact Technical Assistance |