|
|
BRAKE WARNING LAMP BRC-81 < DTC/CIRCUIT DIAGNOSIS > [VDC/TCS/ABS] C D E G H I J K L M A B BRC N O P BRAKE WARNING LAMP Description INFOID:0000000009883714 ×: ON –: OFF NOTE: (when brake fluid is insufficient). • 2: After starting engine, brake warning lamp is turned off. Component Function Check INFOID:0000000009883715 1. BRAKE WARNING LAMP OPERATION CHECK Check that the lamp illuminates after the ignition switch is turned ON, and turns OFF after the engine is started. YES >> Inspection End NO >> Go to diagnosis procedure. Refer to Diagnosis Procedure INFOID:0000000009883716 1. CHECK SELF-DIAGNOSIS Perform ABS actuator and electric unit (control unit) self-diagnosis. Refer to Is the inspection result normal? YES >> GO TO 2 NO >> Check items displayed by self-diagnosis. 2. CHECK COMBINATION METER Check if the indication and operation of combination meter are normal. Refer to . Is the inspection result normal? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-116, "Removal and Installa- . NO >> Replace combination meter. Refer to MWI-93, "Removal and Installation" Special Repair Requirement INFOID:0000000009883717 1. ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION Always perform neutral position adjustment for the steering angle sensor when replacing the ABS actuator and electric unit (control unit). Refer to BRC-8, "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL . >> GO TO 2 2. CALIBRATION OF DECEL G SENSOR Always perform calibration of decel G sensor when replacing the ABS actuator and electric unit (control unit). BRC-9, "CALIBRATION OF DECEL G SENSOR : Description" >> END Condition Brake warning lamp (Note 1) Ignition switch OFF – Ignition switch ON × (Note 2) EBD function is malfunctioning. × |