|
|
MWI-26 < SYSTEM DESCRIPTION > COMPASS 1. Determine your location on the zone map. HomeLink universal transceiver) until the current zone number appears in the display. 4. Press the mode or (N) switch repeatedly until the desired zone number appears in the display. compass direction after a few seconds. NOTE: Use zone number 5 for Hawaii. CALIBRATION PROCEDURE The compass display is equipped with an automatic correction function. If the compass display reads “CAL” or the direction is not shown correctly, perform the correction procedure below. 1. Press and hold the (N) switch (with HomeLink universal trans- ceiver) or the mode switch (without HomeLink universal trans- ceiver) until the display reads “CAL”. 2. Drive the vehicle slowly in a circle, in an open, safe place. The initial calibration is completed in about 3 turns. NOTE: In places where the terrestrial magnetism is extremely disturbed, the initial correction may start automatically. WKIA4889E |