Nissan Quest E52. Manual - part 1160

B1210 SIDE COLLISION DETECTION

SRC-169

< DTC/CIRCUIT DIAGNOSIS >

C

D

E

F

G

I

J

K

L

M

A

B

SRC

N

O

P

B1210 SIDE COLLISION DETECTION

Description

INFOID:0000000009650002

The side air bag and curtain air bag are activated by the air bag diagnosis sensor unit signal transmitted at the
time of side collision.

DTC Logic

INFOID:0000000009650003

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.

CHECK SELF-DIAG RESULT

 With CONSULT

1.

Turn ignition switch ON.

2.

Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

 Without CONSULT

1.

Turn ignition switch ON.

2.

Check the air bag warning lamp status. Refer to 

SRC-15, "On Board Diagnosis Function"

.

NOTE:
SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.

Is malfunctioning part detected?

YES

>> Refer to 

SRC-169, "Diagnosis Procedure"

.

NO

>> INSPECTION END

Diagnosis Procedure

INFOID:0000000009650004

WARNING:

• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3

minutes or more. (To discharge backup capacitor.)

• Never use unspecified tester or other measuring device. 

1.

PERFORM COLLISION DIAGNOSIS

Perform collision diagnosis.Refer to 

SR-7, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated

in a collision"

 or 

SR-8, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a collision"

.

>> GO TO 2.

2.

FINAL INSPECTION

Perform “AIR BAG” Self Diagnostic Result.

Is the inspection result normal?

YES

>> INSPECTION END

NO

>> Peform diagnosis of applicable DTC.Refer to 

SRC-22, "DTC Index"

.

DTC

Display contents of 

CONSULT

DTC detecting condition

Possible cause

B1210

SIDE COLLISION 
DETECTION

Side air bag and curtain air bag are deployed

—

SRC-170

< DTC/CIRCUIT DIAGNOSIS >

B1212, B1213, B1214 SATELLITE SENSOR RH

B1212, B1213, B1214 SATELLITE SENSOR RH

DTC Logic

INFOID:0000000009650005

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.

CHECK SELF-DIAG RESULT

 With CONSULT

1.

Turn ignition switch ON.

2.

Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

 Without CONSULT

1.

Turn ignition switch ON.

2.

Check the air bag warning lamp status. Refer to 

SRC-15, "On Board Diagnosis Function"

.

NOTE:
SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.

Is malfunctioning part detected?

YES

>> Refer to 

SRC-170, "Diagnosis Procedure"

.

NO

>> INSPECTION END

Diagnosis Procedure

INFOID:0000000009650006

WARNING:

• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3

minutes or more. (To discharge backup capacitor.)

• Never use unspecified tester or other measuring device. 

1.

CHECK HARNESS CONNECTOR

Check the harness connector.

Is the inspection result normal?

YES

>> GO TO 2.

NO

>> Replace harness connector.

2.

CHECK WIRING HARNESS

Check the wiring harness externals.

Is the inspection result normal?

YES

>> GO TO 3. 

NO

>> Replace wiring harness.

3.

REPLACE FRONT SATELLITE SENSOR

1.

Replace front satellite sensor RH. Refer to 

SR-26, "Removal and Installation"

.

2.

Perform DTC confirmation procedure. Refer to 

SRC-170, "DTC Logic"

.

Is DTC detected?

YES

>> GO TO 4. 

NO

>> INSPECTION END

4.

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

1.

Replace air bag diagnosis sensor unit. Refer to 

SR-29, "Removal and Installation"

.

2.

Perform DTC confirmation procedure. Refer to 

SRC-170, "DTC Logic"

.

Is DTC detected?

YES

>> GO TO 1. 

DTC

Display contents of 

CONSULT

DTC detecting condition

Possible cause

B1212
B1213
B1214

RH1 SAT-SENS 

Front satellite sensor RH is malfunctioning

• Disconnection of wiring harness
• Malfunction in front satellite sensor RH
• Malfunction in air bag diagnosis sensor unit

B1212, B1213, B1214 SATELLITE SENSOR RH

SRC-171

< DTC/CIRCUIT DIAGNOSIS >

C

D

E

F

G

I

J

K

L

M

A

B

SRC

N

O

P

NO

>> INSPECTION END

SRC-172

< DTC/CIRCUIT DIAGNOSIS >

B1215, B1216, B1217 SATELLITE SENSOR LH

B1215, B1216, B1217 SATELLITE SENSOR LH

DTC Logic

INFOID:0000000009650007

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.

CHECK SELF-DIAG RESULT

 With CONSULT

1.

Turn ignition switch ON.

2.

Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

 Without CONSULT

1.

Turn ignition switch ON.

2.

Check the air bag warning lamp status. Refer to 

SRC-15, "On Board Diagnosis Function"

.

NOTE:
SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.

Is malfunctioning part detected?

YES

>> Refer to 

SRC-172, "Diagnosis Procedure"

.

NO

>> INSPECTION END

Diagnosis Procedure

INFOID:0000000009650008

WARNING:

• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3

minutes or more. (To discharge backup capacitor.)

• Never use unspecified tester or other measuring device. 

1.

CHECK HARNESS CONNECTOR

Check the harness connector.

Is the inspection result normal?

YES

>> GO TO 2.

NO

>> Replace harness connector.

2.

CHECK WIRING HARNESS

Check the wiring harness externals.

Is the inspection result normal?

YES

>> GO TO 3. 

NO

>> Replace wiring harness.

3.

REPLACE FRONT SATELLITE SENSOR

1.

Replace front satellite sensor LH. Refer to 

SR-26, "Removal and Installation"

.

2.

Perform DTC confirmation procedure. Refer to 

SRC-172, "DTC Logic"

Is DTC detected?

YES

>> GO TO 4. 

NO

>> INSPECTION END

4.

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

1.

Replace air bag diagnosis sensor unit. Refer to 

SR-29, "Removal and Installation"

.

2.

Perform DTC confirmation procedure. Refer to 

SRC-172, "DTC Logic"

.

Is DTC detected?

YES

>> GO TO 1. 

DTC

Display contents of 

CONSULT

DTC detecting condition

Possible cause

B1215
B1216
B1217

LH1 SAT-SENS 

Front satellite sensor LH is malfunctioning

• Disconnection of wiring harness
• Malfunction in front satellite sensor LH
• Malfunction in air bag diagnosis sensor unit