|
|
HAC-194 < ECU DIAGNOSIS INFORMATION > [MANUAL AIR CONDITIONING] BCM (BODY CONTROL MODULE) REAR WIPER MOTOR PROTECTION BCM detects the rear wiper stopping position according to the rear wiper auto stop signal. Condition of cancellation 1. Pass more than 1 minute after the rear wiper stop. 2. Turn rear wiper switch OFF. 3. Operate the rear wiper switch or rear washer switch. BCM (BODY CONTROL SYSTEM) (WITHOUT INTELLIGENT KEY SYSTEM) : INFOID:0000000010269358 If some DTCs are displayed at the same time, perform inspections one by one based on the following priority BCM (BODY CONTROL SYSTEM) (WITHOUT INTELLIGENT KEY SYSTEM) : INFOID:0000000010269359 NOTE: Details of time display • CRNT: Displays when there is a malfunction now or after returning to the normal condition until turning igni- tion switch OFF → ON again. • 1 - 39: Displayed if any previous malfunction is present when current condition is normal. It increases like 1 → 2 → 3...38 → 39 after returning to the normal condition whenever ignition switch OFF → ON. The counter remains at 39 even if the number of cycles exceeds it. It is counted from 1 again when turning ignition switch → ON after returning to the normal condition if the malfunction is detected again. Display contents of CONSULT Fail-safe Cancellation B2190: NATS ANTENNA AMP Inhibit engine cranking Erase DTC B2191: DIFFERENCE OF KEY Inhibit engine cranking Erase DTC B2192: ID DISCORD BCM-ECM Inhibit engine cranking Erase DTC B2193: CHAIN OF BCM-ECM Inhibit engine cranking Erase DTC B2195: ANTI SCANNING Inhibit engine cranking Ignition switch ON → OFF Priority DTC 1 • U1000: CAN COMM 2 • B2190: NATS ANTENNA AMP 3 C1735: IGN CIRCUIT OPEN 4 • C1704: LOW PRESSURE FL |