Nissan Versa Note. Manual - part 199
DOOR LOCK ACTUATOR
DLK-81
< DTC/CIRCUIT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
2.
CHECK DOOR LOCK ACTUATOR CIRCUIT
1. Disconnect BCM connector and all door lock actuator connectors.
2. Check continuity between BCM harness connector and rear door lock actuator LH harness connector.
3. Check continuity between BCM harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace harness.
3.
CHECK BCM OUTPUT SIGNAL
1. Connect BCM connector.
2. Check voltage between rear door lock actuator LH harness connector and ground.
Is the inspection result normal?
YES
>> Check for internal short of each door lock actuator.
NO
>> Replace BCM. Refer to
BCS-70, "Removal and Installation"
REAR RH
REAR RH : Component Function Check
INFOID:0000000009645312
1.
CHECK FUNCTION
1. Select DOOR LOCK of BCM using CONSULT.
2. Select DOOR LOCK in ACTIVE TEST mode.
3. Touch ALL LOCK or ALL UNLK to check that it works normally.
Is the inspection result normal?
YES
>> Door lock actuator is OK.
NO
>> Refer to
DLK-81, "REAR RH : Diagnosis Procedure"
.
REAR RH : Diagnosis Procedure
INFOID:0000000009645313
Regarding Wiring Diagram information, refer to
DLK-51, "POWER DOOR LOCK SYSTEM : Wiring Diagram"
.
1.
CHECK DOOR LOCK ACTUATOR INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect rear door lock actuator RH connector.
3. Check voltage between rear door lock actuator RH harness connector and ground.
BCM
Rear door lock actuator LH
Continuity
Connector
Terminal
Connector
Terminal
M99
65
D205
1
Yes
55
2
BCM
Ground
Continuity
Connector
Terminal
M99
65
No
55
(+)
(–)
Condition
Voltage
(Approx.)
BCM
Connector
Terminal
M99
65
Ground
Door lock and unlock switch
Lock
Battery voltage
55
Unlock