Content .. 654 655 656 657 ..

Nissan Rogue. Manual - part 656

B20E3 LED HEADLAMP LH

EXL-253

< DTC/CIRCUIT DIAGNOSIS >

[LED HEADLAMP]

EXL

B20E3 LED HEADLAMP LH

DTC Logic

INFOID:0000000011280893

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

SELF DIAGNOSTIC RESULT

1. Turn ignition switch ON.

2. Check “Self Diagnostic Result” with CONSULT.
Is DTC detected?

YES

>> Refer to

EXL-253, "Diagnosis Procedure"

>> Inspection End.

Diagnosis Procedure

INFOID:0000000011280894

CHECK FRONT COMBINATION LAMP LH SHORT CIRCUIT TO GROUND

1. Disconnect front combination lamp LH connector and IPDM E/R connector.

2. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal?

YES

>> GO TO 2.

>> Repair or replace harness.

CHECK FRONT COMBINATION LAMP LH SHORT CIRCUIT TO GROUND

1. Reconnect IPDM E/R connector.

2. Check continuity between front combination lamp LH harness connector and ground.

Is the inspection result normal?

YES

>> Replace front combination lamp LH. Refer to

EXL-266, "Removal and Installation"

>> Replace IPDM E/R. Refer to

PCS-40, "Removal and Installation"

DTC

No.

Self-diagnosis item

DTC Detection Condition

Possible causes

B20E3

LED HEADLAMP LH
[CMPNENT INTERNAL
MLFNCTN]

Detection signal circuit short to ground

• Harness or connectors between the front com-

bination lamp LH and the IPDM E/R

• IPDM E/R

IPDM E/R

Ground

Continuity

Connector

Terminal

E217

Front combination lamp LH

Ground

Connector

Terminal

E239

EXL-254

< SYMPTOM DIAGNOSIS >

[LED HEADLAMP]

EXTERIOR LIGHTING SYSTEM SYMPTOMS

SYMPTOM DIAGNOSIS

EXTERIOR LIGHTING SYSTEM SYMPTOMS

Symptom Table

INFOID:0000000011280895

CAUTION:

Perform the “Self Diagnostic Result” with CONSULT before the symptom diagnosis. Perform the trou-

ble diagnosis if any DTC is detected.

Symptom

Possible cause

Inspection item

Headlamp (HI) is not
turned ON.

One side

• Fuse
• LED
• Harness between IPDM E/R

and headlamp (HI)

• Harness between headlamp

(HI) and ground

• IPDM E/R

Headlamp (HI) circuit
Refer to

EXL-244, "DTC Logic"

(LH)

EXL-245, "DTC Logic"

(RH).

Both sides

Symptom diagnosis
“BOTH SIDE HEADLAMPS (HI)
ARE NOT TURNED ON”
Refer to

EXL-244, "DTC Logic"

(LH) or

EXL-245, "DTC Logic"

(RH).

High beam indicator lamp is not turned ON.
[Headlamp (HI) is turned ON.]

Combination meter

• Combination meter

“Data Monitor” “HI-BEAM IND”

• BCM (HEAD LAMP)

“Active Test” “HEADLAMP”

Headlamp (LO) is not
turned ON.

One side

• Fuse
• LED
• Harness between IPDM E/R

and headlamp lamp (LO)

• Harness between headlamp

(LO) and ground

• IPDM E/R

Headlamp (LO) circuit
Refer to

EXL-246, "DTC Logic"

(LH)

EXL-247, "DTC Logic"

(RH).

Both sides

Symptom diagnosis
“BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON”
Refer to

EXL-246, "DTC Logic"

(LH) or

EXL-247, "DTC Logic"

(RH).

Each lamp is not turned ON/OFF with lighting switch
AUTO.

• Combination switch
• Harness between combination

switch and BCM

• BCM

Combination switch
Refer to

BCS-73, "Symptom Table"

(with Intelligent Key system) or

BCS-133, "Symptom Table"

(with-

out Intelligent Key system).

• Optical sensor
• Harness between optical sen-

sor and BCM

• BCM

Optical sensor
Refer to

EXL-87, "Component

Function Check"

Daytime running light is not turned ON.
[Headlamp (HI) is turned ON.]

• Fuse
• Harness between IPDM E/R

and front combination lamp

• IPDM E/R
• BCM
• ECM
• Combination meter

• Daytime running light circuit

Refer to

EXL-236, "DTC Logic"

• BCM (HEADLAMP)

“Data Monitor” “ENGINE STATE”

• Combination meter

“Data Monitor” “PKB SW”

• BCM (HEADLAMP)

“Active Test” “DAYTIME RUN-
NING LIGHT”

Parking lamp is not turned ON.

• Fuse
• Parking lamp bulb
• Harness between IPDM E/R

and front combination lamp

• IPDM E/R

Parking lamp circuit
Refer to

EXL-248, "DTC Logic"

EXTERIOR LIGHTING SYSTEM SYMPTOMS

EXL-255

< SYMPTOM DIAGNOSIS >

[LED HEADLAMP]

EXL

Front side marker lamp is not turned ON.

• Front side marker lamp bulb
• Harness between IPDM E/R

and front side marker lamp

• Harness between front side

marker lamp and ground

• IPDM E/R

Front side marker lamp circuit
Refer to

EXL-248, "DTC Logic"

License plate lamp is not turned ON.

• License plate lamp bulb
• Harness between IPDM E/R

and license plate lamp

• Harness between license plate

lamp and ground

License plate lamp circuit
Refer to

EXL-249, "DTC Logic"

Parking lamp, side marker lamp, tail lamp and li-
cense plate lamp are not turned ON.

Symptom diagnosis
“PARKING, SIDE MARKER, LICENSE PLATE AND TAIL LAMPS ARE
NOT TURNED ON”
Refer to

EXL-259, "Description"

Tail lamp indicator is not turned ON.
(Exterior lamps are turned ON.)

Combination meter

• Combination meter

“Data Monitor” “LIGHT IND”

• BCM (HEADLAMP)

“Active Test” “TAIL LAMP”

Turn signal lamp does not
blink.

Indicator lamp is nor-
mal.
(Applicable side per-
forms high flasher acti-
vation.)

• Turn signal lamp bulb
• Door mirror
• Harness between BCM and

each turn signal lamp

• Harness between each turn sig-

nal lamp and ground

Turn signal lamp circuit
Refer to

EXL-231, "Component

Function Check"

Turn signal indicator lamp
does not blink.
(Turn signal lamp is nor-
mal.)

One side

Combination meter

—

Both sides
(Always)

• Turn signal indicator lamp sig-

nal

• BCM
• Combination meter

• Combination meter

“Data Monitor” “TURN IND”

• BCM (FLASHER)

“Active Test” “FLASHER”

Both sides
(Only when activating
hazard warning lamp
with ignition switch
OFF)

• Combination meter power sup-

ply and ground circuit

• Combination meter

Combination meter
Power supply and ground circuit
Refer to

MWI-60, "COMBINATION

METER : Diagnosis Procedure"

• Hazard warning lamp does not activate.
• Hazard warning lamp continues activating.
(Turn signal is normal.)

• Hazard switch
• Harness between hazard

switch and BCM

• Harness between hazard

switch and ground

• BCM

Hazard switch circuit
Refer to

EXL-90, "Component

Function Check"

Front fog lamp is not
turned ON.

One side

• Front fog lamp bulb
• Harness between IPDM E/R

and front fog lamp

• Harness between front fog lamp

and ground

• IPDM E/R

Front fog lamp circuit
Refer to

EXL-235, "DTC Logic"

(LH)

EXL-237, "DTC Logic"

(RH).

Both sides

Symptom diagnosis
“BOTH SIDE FRONT FOG LAMPS ARE NOT TURNED ON”
Refer to

EXL-235, "DTC Logic"

(LH) or

EXL-237, "DTC Logic"

(RH).

Symptom

Possible cause

Inspection item

EXL-256

< SYMPTOM DIAGNOSIS >

[LED HEADLAMP]

NORMAL OPERATING CONDITION

NORMAL OPERATING CONDITION

Description

INFOID:0000000011280896

AUTO LIGHT SYSTEM

The headlamp may not be turned ON/OFF immediately after passing dark area or bright area (short tunnel,

sky bridge, shadowed area, etc.) while using the auto light system. This is caused by the control difference.

This is normal.

Content .. 654 655 656 657 ..