Nissan Rogue. Manual - part 269

DAS

C1BC0-00 FRONT RIGHT WHEEL SENSOR

DAS-247

< DTC/CIRCUIT DIAGNOSIS >

[CHASSIS CONTROL]

C

D

E

F

G

H

I

J

K

L

M

B

N

P

A

4. Perform “All DTC Reading”.
Is DTC “C1BC0-00”, “U1000-00” or other DTC detected?

YES (“C1BC0-00”)>>Replace the chassis control module. Refer to 

DAS-286, "Removal and Installation"

.

YES (“U1000-00”)>>Refer to 

DAS-260, "Diagnosis Procedure"

.

YES (other DTC)>>Check the DTC.

NO

>> Inspection End.

DAS-248

< DTC/CIRCUIT DIAGNOSIS >

[CHASSIS CONTROL]

C1BC1-00 FRONT LEFT WHEEL SENSOR

C1BC1-00 FRONT LEFT WHEEL SENSOR

DTC Description

INFOID:0000000011277418

DTC DETECTION LOGIC

POSSIBLE CAUSE

• Front left wheel sensor

• Front left sensor rotor

• ABS actuator and electric unit (control unit)

• Chassis control module

FAIL-SAFE

The following functions are suspended:

• Active Trace Control function

• Active Ride Control function

DTC CONFIRMATION PROCEDURE

1.

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn the ignition switch OFF

and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.

CHECK DTC DETECTION

With CONSULT

1. Start the engine.

2. Drive the vehicle at approx. 30 km/h (19 MPH) or more for approx. 1 minute.

3. Stop the vehicle.

4. Turn the ignition switch OFF to ON.

CAUTION:

Be sure to wait of 10 seconds after turning ignition switch OFF or ON.

5. Perform “Self Diagnostic Result” of “CHASSIS CONTROL”.
Is DTC “C1BC1-00” detected?

YES

>> Proceed to 

DAS-248, "Diagnosis Procedure"

.

NO-1 >> To check malfunction symptom before repair: Refer to 

GI-44, "Intermittent Incident"

.

NO-2 >> Confirmation after repair: Inspection End.

Diagnosis Procedure

INFOID:0000000011277419

1.

CHECK FRONT LH WHEEL SENSOR SYSTEM

With CONSULT

Perform “Self Diagnostic Result” of “ABS”.
Is DTC detected?

YES

>> Check the DTC. Refer to 

BRC-53, "DTC Index"

.

NO

>> GO TO 2.

2.

PERFORM SELF-DIAGNOSIS

With CONSULT

1. Erase “Self Diagnostic Result” of “CHASSIS CONTROL”.

2. Turn the ignition switch OFF and wait for 10 seconds or more.

3. Turn the ignition switch ON.

DTC

Display Item

(Trouble diagnosis content)

Malfunction detected condition

C1BC1-00

FL WHEEL SENSOR
(Front left wheel sensor)

When a malfunction is detected in front left wheel sensor system.

DAS

C1BC1-00 FRONT LEFT WHEEL SENSOR

DAS-249

< DTC/CIRCUIT DIAGNOSIS >

[CHASSIS CONTROL]

C

D

E

F

G

H

I

J

K

L

M

B

N

P

A

4. Perform “All DTC Reading”.
Is DTC “C1BC1-00”, “U1000-00” or other DTC detected?

YES (“C1BC1-00”)>>Replace the chassis control module. Refer to 

DAS-286, "Removal and Installation"

.

YES (“U1000-00”)>>Refer to 

DAS-260, "Diagnosis Procedure"

.

YES (other DTC)>>Check the DTC.

NO

>> Inspection End.

DAS-250

< DTC/CIRCUIT DIAGNOSIS >

[CHASSIS CONTROL]

C1BC2-00 REAR RIGHT WHEEL SENSOR

C1BC2-00 REAR RIGHT WHEEL SENSOR

DTC Description

INFOID:0000000011277420

DTC DETECTION LOGIC

POSSIBLE CAUSE

• Rear right wheel sensor

• Rear right sensor rotor

• ABS actuator and electric unit (control unit)

• Chassis control module

FAIL-SAFE

The following functions are suspended:

• Active Trace Control function

• Active Ride Control function

DTC CONFIRMATION PROCEDURE

1.

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn the ignition switch OFF

and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.

CHECK DTC DETECTION

With CONSULT

1. Start the engine.

2. Drive the vehicle at approx. 30 km/h (19 MPH) or more for approx. 1 minute.

3. Stop the vehicle.

4. Turn the ignition switch OFF to ON.

CAUTION:

Be sure to wait of 10 seconds after turning ignition switch OFF or ON.

5. Perform “Self Diagnostic Result” of “CHASSIS CONTROL”.
Is DTC “C1BC2-00” detected?

YES

>> Proceed to 

DAS-250, "Diagnosis Procedure"

.

NO-1 >> To check malfunction symptom before repair: Refer to 

GI-44, "Intermittent Incident"

.

NO-2 >> Confirmation after repair: Inspection End.

Diagnosis Procedure

INFOID:0000000011277421

1.

CHECK REAR RH WHEEL SENSOR SYSTEM

With CONSULT

Perform “Self Diagnostic Result” of “ABS”.
Is DTC detected?

YES

>> Check the DTC. Refer to 

BRC-53, "DTC Index"

.

NO

>> GO TO 2.

2.

PERFORM SELF-DIAGNOSIS

With CONSULT

1. Erase “Self Diagnostic Result” of “CHASSIS CONTROL”.

2. Turn the ignition switch OFF and wait for 10 seconds or more.

3. Turn the ignition switch ON.

DTC

Display Item

(Trouble diagnosis content)

Malfunction detected condition

C1BC2-00

RR WHEEL SENSOR
(Rear right wheel sensor)

When a malfunction is detected in rear right wheel sensor system.