|
|
BCS-126 < DTC/CIRCUIT DIAGNOSIS > [WITHOUT INTELLIGENT KEY SYSTEM] U0415 VEHICLE SPEED SIG U0415 VEHICLE SPEED SIG Description INFOID:0000000011280273 U0415 is displayed if any unusual condition is present in the reception status of the vehicle speed signal from the ABS actuator and electric unit (control unit). DTC Logic INFOID:0000000011280274 DTC DETECTION LOGIC NOTE: • If DTC U0415 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to • If DTC U0415 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC CONFIRMATION PROCEDURE 1. DTC CONFIRMATION 1. Erase the DTC. 2. Turn ignition switch OFF. 3. Perform “Self Diagnostic Result” of “BCM” with CONSULT, after the ignition switch has been turned ON for 2 seconds or more. Is any DTC detected? YES >> Refer to NO >> Inspection End. Diagnosis Procedure INFOID:0000000011280275 1. ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF DIAGNOSTIC RESULT Perform “Self Diagnostic Result” of “ABS” with CONSULT. Refer to . Is any DTC detected? YES >> Perform the trouble diagnosis related to the detected DTC. Refer to . NO >> GO TO 2. 2. CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT . Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness or connectors. 3. COMBINATION METER SELF DIAGNOSTIC RESULT Perform “Self Diagnostic Result” of “METER M&A” with CONSULT. Refer to Is any DTC detected? YES >> Perform the trouble diagnosis related to the detected DTC. Refer to . NO >> Refer to GI-44, "Intermittent Incident" . CONSULT Display DTC Detection Condition Possible Cause VEHICLE SPEED SIG When the vehicle speed signal received from the • ABS system |