|
|
DIAGNOSIS SYSTEM (BCM) (WITH INTELLIGENT KEY SYSTEM) EXL-19 < SYSTEM DESCRIPTION > C D E F G H I J K M A B EXL N O P HEADLAMP INFOID:0000000010304492 DATA MONITOR ACTIVE TEST WORK SUPPORT Monitor Item [Unit] Description PUSH SW [On/Off] Indicates condition of push-button ignition switch. ENGINE STATE [Stop/Stall/Crank/Run] Indicates engine status received from ECM on CAN communication line. VEH SPEED 1 [km/h] Indicates vehicle speed signal received from ABS on CAN communication line. TURN SIGNAL R [On/Off] Indicates condition of combination switch. TURN SIGNAL L [On/Off] TAIL LAMP SW [On/Off] HI BEAM SW [On/Off] HEAD LAMP SW 1 [On/Off] HEAD LAMP SW 2 [On/Off] PASSING SW [On/Off] AUTO LIGHT SW [On/Off] FR FOG SW [On/Off] DOOR SW-DR [On/Off] Indicates condition of front door switch LH. DOOR SW-AS [On/Off] Indicates condition of front door switch RH. DOOR SW-RR [On/Off] Indicates condition of rear door switch RH. DOOR SW-RL [On/Off] Indicates condition of rear door switch LH. DOOR SW-BK [On/Off] Indicates condition of trunk switch. OPTI SEN (DTCT) [V] Indicates outside brightness voltage signal from optical sensor. OPTI SEN (FILT) [V] Indicates outside brightness voltage signal from optical sensor filtered by BCM. Test Item Description FR FOG LAMP This test is able to check front fog lamp operation [On/Off]. HEAD LAMP This test is able to check head lamp operation [Hi/Low/Off]. ILL DIM SIGNAL This test is able to check head lamp illumination dimming operation [On/Off]. TAIL LAMP This test is able to check tail lamp operation [On/Off]. Support Item Setting Description AUTO LIGHT LOGIC SET MODE 1* With twilight ON custom & with wiper INT, LO and HI MODE 2 Witt twilight ON custom & with wiper LO and HI MODE 3 With twilight ON custom & without MODE 4 Without twilight ON custom & with wiper INT, LO and HI MODE 5 Without twilight ON custom & with wiper LO and HI MODE 6 Without twilight ON custom & without BATTERY SAVER SET On* Exterior lamp battery saver function ON. Off Exterior lamp battery saver function OFF. |