|
|
LAN-190 < DTC/CIRCUIT DIAGNOSIS > [CAN SYSTEM (TYPE 4)] VSP BRANCH LINE CIRCUIT VSP BRANCH LINE CIRCUIT Diagnosis Procedure INFOID:0000000010415444 1. CHECK CONNECTOR 1. Turn the power switch OFF. 2. Disconnect the 12V battery cable from the negative terminal. Refer to LAN-26, "Precautions for Removing 3. Check the terminals and connectors of the approaching vehicle sound for pedestrians (VSP) control unit for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? YES >> GO TO 2. NO >> Repair the terminal and connector. 2. CHECK HARNESS FOR OPEN CIRCUIT 1. Disconnect the connector of approaching vehicle sound for pedestrians (VSP) control unit. 2. Check the resistance between the approaching vehicle sound for pedestrians (VSP) control unit harness connector terminals. Is the measurement value within the specification? YES >> GO TO 3. NO >> Repair the approaching vehicle sound for pedestrians (VSP) control unit branch line. 3. CHECK POWER SUPPLY AND GROUND CIRCUIT Check the power supply and the ground circuit of the approaching vehicle sound for pedestrians (VSP) control unit. Refer to VSP-47, "APPROACHING VEHICLE SOUND FOR PEDESTRIANS (VSP) CONTROL UNIT : Is the inspection result normal? YES (Present error)>>Replace the approaching vehicle sound for pedestrians (VSP) control unit. Refer to VSP-67, "Removal and Installation" YES (Past error)>>Error was detected in the approaching vehicle sound for pedestrians (VSP) control unit branch line. NO >> Repair the power supply and the ground circuit. Approaching vehicle sound for pedestrians (VSP) control unit harness connector Resistance ( Ω) Connector No. Terminal No. M47 4 12 Approx. 54 – 66 |