|
|
SYSTEM SETTING HAC-83 < BASIC INSPECTION > [AUTO A/C (WITH HEAT PUMP)] C D E F G H J K L M A B HAC N O P SYSTEM SETTING Temperature Setting Trimmer INFOID:0000000010121783 DESCRIPTION If the temperature felt by the customer is different from the air flow temperature controlled by the temperature setting, the A/C auto amp. control temperature can be adjusted to compensate for the temperature setting. HOW TO SET With CONSULT Perform “TEMP SET CORRECT” in “Work support” of “HVAC”. NOTE: • When −3.0°C (−6°F) is corrected on the temperature setting set as 25.0°C (77°F) the temperature controlled by A/C auto amp. is 25.0 °C (77°F) −3.0°C (−6°F) = 22.0°C (72°F) and the temperature becomes lower than the temperature setting. • When the 12V battery cable is disconnected from the negative terminal or when the 12V battery voltage becomes 10 V or less, the setting of the difference between the set temperature and control temperature may be cancelled. Inlet Port Memory Function (REC) INFOID:0000000010121784 DESCRIPTION • If the ignition switch is turned to the OFF position while the intake switch is set to ON (recirculation), “Per- form the memory” or “Do not perform the memory” of intake switch ON (recirculation) condition can be selected. • If “Perform the memory” is set, the intake switch is ON (recirculation) when turning the ignition switch to the ON position again. • If “Do not perform the memory” is set, the air inlets is controlled automatically when turning the ignition switch to the ON position again. HOW TO SET With CONSULT Perform the “REC MEMORY SET” in “Work support” of “HVAC”. NOTE: Work support items Display ( °C) Display ( °F) TEMP SET CORRECT 3.0 6 2.5 5 2.0 4 1.5 3 1.0 2 0.5 1 0 (initial status) 0 (initial status) −0.5 −1 −1.0 −2 −1.5 −3 −2.0 −4 −2.5 −5 −3.0 −6 Work support items Display Setting REC MEMORY SET WITHOUT (initial status) Perform the memory of manual REC WITH Do not perform the memory of manual REC (auto control) |