|
|
EVC-400 < DTC/CIRCUIT DIAGNOSIS > CHARGING CONNECTOR LOCK SWITCH 15. CHECK CHARGE CONNECTOR LOCK SWITCH ILLUMINATION LAMP POWER SUPPLY CIRCUIT 1. Disconnect charge connector lock switch harness connector. 2. Check the continuity between charge connector lock switch harness connector and fuse terminal. Is the inspection result normal? YES >> Check power supply circuit. NO >> Repair or replace error-detected parts. 16. CHECK CHARGE CONNECTOR LOCK SWITCH INDICATOR CIRCUIT 1. Turn power switch OFF. 2. Disconnect charge connector lock switch harness connector. 3. Disconnect VCM harness connector. 4. Check the continuity between charge connector lock switch and VCM harness connector. 5. Also check harness for short to ground and short to power. YES >> GO TO 17. NO >> Repair or replace error-detected parts. 17. CHECK VCM GROUND CIRCUIT Check the continuity between VCM harness connector and ground. Is the inspection result normal? YES >> Replace charge connector lock switch. Refer to VC-146, "Removal and Installation" NO >> Repair or replace error-detected parts. 18. CHECK CHARGE CONNECTOR LOCK SWITCH Check charge connector lock switch. Refer to EVC-401, "Component Inspection (Charge Connector Lock . Is the inspection result normal? YES >> GO TO 19. NO >> Replace charge connector lock switch. Refer to VC-146, "Removal and Installation" 19. CHECK CHARGE CONNECTOR LOCK SWITCH SIGNAL POWER SUPPLY 1. Turn power switch ON. + − Continuity Charge connector lock switch Connector Terminal M94 10 #12 fuse termi- nal Existed + − Continuity Charge connector lock switch VCM Connector Terminal Connector Terminal M94 5 E62 91 Existed + − Continuity VCM Connector Terminal E61 58 Ground Existed 65 E62 118 126 |