Nissan Leaf. Manual - part 452

 

  Index      Nissan     Nissan Leaf (2011-2014 year) - Service and Repair Manual

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  450  451  452  453   ..

 

 

Nissan Leaf. Manual - part 452

 

 

P3097-P30A2 CELL CONTROLLER ASIC OPEN

EVB-91

< DTC/CIRCUIT DIAGNOSIS >

D

E

F

G

H

I

J

K

L

M

A

B

EVB

N

O

P

P3097-P30A2 CELL CONTROLLER ASIC OPEN

DTC Logic

INFOID:0000000010121079

DTC DETECTION LOGIC

DTC DETECTION LOGIC

1.

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

1. Power switch ON and wait for 10 seconds or more.

2. Select “Self Diagnostic Result” of “HV BAT”.

3. Check DTC.
Is P308B-P30A2 detected?

YES

>> Refer to 

EVB-91, "Diagnosis Procedure"

.

NO

>> INSPECTION END

Diagnosis Procedure

INFOID:0000000010121080

DANGER:

Since hybrid vehicles and electric vehicles contain a high voltage battery, there is the risk of

electric shock, electric leakage, or similar accidents if the high voltage component and vehicle are

handled incorrectly. Be sure to follow the correct work procedures when performing inspection and

maintenance.

WARNING:

• Be sure to remove the service plug in order to disconnect the high voltage circuits before perform-

ing inspection or maintenance of high voltage system harnesses and parts.

• The removed service plug must always be carried in a pocket of the responsible worker or placed in

the tool box during the procedure to prevent the plug from being connected by mistake.

• Be sure to wear insulating protective equipment consisting of glove, shoes, face shield and glasses

before beginning work on the high voltage system.

• Never allow workers other than the responsible person to touch the vehicle containing high voltage

parts. To keep others from touching the high voltage parts, these parts must be covered with an insu-

lating sheet except when using them.

• Refer to 

EVB-7, "High Voltage Precautions"

.

CAUTION:

Never bring the vehicle into the READY status with the service plug removed unless otherwise

instructed in the Service Manual. A malfunction may occur if this is not observed.

1.

PERFORM THE SELF-DIAGNOSIS OF LI-ION BATTERY CONTROLLER

DTC

Trouble diagnosis name

DTC detecting condition

Possible causes

P3097

CELL CONT ASIC13 OPEN

Self diagnosis program of Li-ion battery controller de-
tects an open circuit in the cell voltage detection line.

• Li-ion battery controller
• Harness or connector

P3098

CELL CONT ASIC14 OPEN

P3099

CELL CONT ASIC15 OPEN

P309A

CELL CONT ASIC16 OPEN

P309B

CELL CONT ASIC17 OPEN

P309C

CELL CONT ASIC18 OPEN

P309D

CELL CONT ASIC19 OPEN

P309E

CELL CONT ASIC20 OPEN

P309F

CELL CONT ASIC21 OPEN

P30A0

CELL CONT ASIC22 OPEN

P30A1

CELL CONT ASIC23 OPEN

P30A2

CELL CONT ASIC24 OPEN

EVB-92

< DTC/CIRCUIT DIAGNOSIS >

P3097-P30A2 CELL CONTROLLER ASIC OPEN

With CONSULT

1. Select “Self Diagnostic Result” mode of “HV BAT” using CONSULT.

2. Check to see if “P3049”-“P3060” (CELL CONT ASIC VOLT related codes) or “P3375”-“P33A4” (CELL

OVER DISCHARGE related codes) is detected simultaneously with “P3097”-“P30A2”.

Is P3049-P3060 or P3375-P33A4 detected?

YES-1 >> “P3049”-“P3060” are detected simultaneously.

• When “P3049”-“P3054” are detected simultaneously, perform the diagnosis procedure of

“P3049”-“P3054”. Refer to 

EVB-81, "Diagnosis Procedure"

• When “P3055”-“P3060” are detected simultaneously, perform the diagnosis procedure of

“P3055”-“P3060”. Refer to 

EVB-83, "Diagnosis Procedure"

YES-2 >> “P3375”-“P33A4” are detected simultaneously.

• When “P3375”-“P3380” are detected simultaneously, perform the diagnosis procedure of

“P3375”-“P3380”. Refer to 

EVB-122, "Diagnosis Procedure"

.

• When “P3381”-“P338C” are detected simultaneously, perform the diagnosis procedure of

“P3381”-“P338C”. Refer to 

EVB-126, "Diagnosis Procedure"

.

• When “P338D”-“P3398” are detected simultaneously, perform the diagnosis procedure of

“P338D”-“P3398”. Refer to 

EVB-130, "Diagnosis Procedure"

.

• When “P3399”-“P33A4” are detected simultaneously, perform the diagnosis procedure of

“P3399”-“P33A4”. Refer to 

EVB-133, "Diagnosis Procedure"

NO

>> GO TO 2.

2.

PRECONDITIONING

WARNING:

Disconnect high voltage. Refer to 

GI-33, "How to Disconnect High Voltage"

.

1. Remove Li-ion battery. Refer to 

EVB-181, "Removal and Installation"

.

2. Remove battery pack upper case. Refer to 

EVB-191, "BATTERY PACK UPPER CASE : Removal and

Installation"

.

>> GO TO 3.

3.

CHECK CONNECTION STATUS

1. Power switch OFF.

2. Check connection status of Li-ion battery controller harness connector and module harness connector.
Is the inspection result normal?

YES

>> GO TO 4.

NO

>> Recover the connection status.

4.

CHECK HARNESS BETWEEN LI-ION BATTERY CONTROLLER AND MODULE

1. Disconnect Li-ion battery controller harness connector and Module harness connector.

2. Refer to below table and continuity between Li-ion battery controller and Module, according to detected

DTC.

DTC

Module 

No.

Module

Li-ion battery controller

Continuity

Connector

Terminal

Connector

Terminal

P3097

25

LB8

10

LB15

110

Existed

26

12

111

P3098

27

LB8

28

LB15

112

Existed

28

26

113

P3099

29

LB8

23

LB15

114

Existed

30

19

115

P309A

31

LB8

3

LB15

116

Existed

32

18

117

P309B

33

LB8

2

LB15

118

Existed

34

6

119

P3097-P30A2 CELL CONTROLLER ASIC OPEN

EVB-93

< DTC/CIRCUIT DIAGNOSIS >

D

E

F

G

H

I

J

K

L

M

A

B

EVB

N

O

P

Is the inspection result normal?

YES

>> Replace Li-ion battery controller. Refer to 

EVB-201, "LI-ION BATTERY CONTROLLER : Removal

and Installation"

.

NO

>> Repair harness or connector.

P309C

35

LB8

22

LB15

120

Existed

36

7

121

P309D

37

LB7

38

LB15

122

Existed

38

51

123

P309E

39

LB7

39

LB15

124

Existed

40

43

125

P309F

41

LB7

55

LB15

127

Existed

42

42

128

P30A0

43

LB7

52

LB15

130

Existed

44

50

138

P30A1

45

LB7

35

LB15

140

Existed

46

33

141

P30A2

47

LB7

46

LB15

142

Existed

48

48

143

DTC

Module 

No.

Module

Li-ion battery controller

Continuity

Connector

Terminal

Connector

Terminal

EVB-94

< DTC/CIRCUIT DIAGNOSIS >

P30E0 DLC DIAGNOSIS VCM

P30E0 DLC DIAGNOSIS VCM

DTC Logic

INFOID:0000000010121081

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

1. Power switch ON and wait for 10 seconds or more.

2. Select “Self Diagnostic Result” of “HV BAT”.

3. Check DTC.
Is P30E0 detected?

YES

>> Refer to 

EVB-94, "Diagnosis Procedure"

.

NO

>> INSPECTION END

Diagnosis Procedure

INFOID:0000000010121082

1.

PERFORM THE SELF-DIAGNOSIS

With CONSULT

1. Perform "All DTC Reading".

2. Check “Self diagnostic result” of systems other than “HV BAT” to see if “P30E0” is detected. 
Is P30E0 detected?

YES

>> Replace VCM. Refer to 

EVC-423, "Removal and Installation"

.

NO

>> GO TO 2.

2.

PERFORM THE SELF-DIAGNOSIS OF LI-ION BATTERY CONTROLLER

With CONSULT

1. Select “Self Diagnostic Result” of “HV BAT”.

2. Check to see if “U1000” is detected simultaneously with “P30E0”.
Is U1000 detected?

YES

>> Replace Li-ion battery controller. Refer to 

EVB-201, "LI-ION BATTERY CONTROLLER : Removal

and Installation"

.

NO

>> INSPECTION END

DTC

Trouble diagnosis name

DTC detecting condition

Possible causes

P30E0

DLC DIAGNOSIS VCM

When no CAN communication signal is received from 
VCM continuously for 2 seconds or more.

• CAN communication line
• Li-ion battery controller
• VCM

 

 

 

 

 

 

 

Content   ..  450  451  452  453   ..