|
|
WT-22 < DTC/CIRCUIT DIAGNOSIS > C1735 IGNITION SIGNAL C1735 IGNITION SIGNAL Description INFOID:0000000009483084 The BCM monitors the IGN ON signal on the CAN line and compares it to it’s direct IGN ON signal. When these two signals do not match, the BCM sets C1735. DTC Logic INFOID:0000000009483085 NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. • Activate and display TPMS transmitter IDs • Display tire pressure reported by the TPMS transmitter • Read TPMS DTCs • Register TPMS transmitter IDs DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. CHECK SELF-DIAGNOSTIC RESULTS 1. On SELECT DIAG MODE, select the SELF-DIAG RESULT screen. 2. Check display contents on SELF DIAG RESULT screen. YES >> Refer to . NO >> Inspection End. Diagnosis Procedure INFOID:0000000009483086 NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. • Activate and display TPMS transmitter IDs • Display tire pressure reported by the TPMS transmitter • Read TPMS DTCs • Register TPMS transmitter IDs MALFUNCTION CODE NO. 54 (DTC C1735) 1. CAN IGNITION SIGNAL Check BCM IGN RLY signal with CONSULT. Refer to Are the inspection results normal with the ignition switch ON? YES >> GO TO 2. NO >> Check CAN system. Refer to LAN-14, "Trouble Diagnosis Flow Chart" 2. BCM POWER SUPPLY Check BCM power supply (ignition ON). Refer to Is the power supply with the ignition switch ON normal? YES >> GO TO 3. NO >> Repair power supply as necessary. 3. DRIVE VEHICLE Clear DTC and then test drive the vehicle and check the low tire pressure warning lamp. YES >> Inspection End. NO >> Replace BCM. Refer to BCS-50, "Removal and Installation" DTC CONSULT DTC detecting condition C1735 IGNITION SIGNAL LINE - BCM/TPMS BCM has detected a mismatch between IGN ON signals. |