|
|
ENGINE MAINTENANCE MA-17 < ON-VEHICLE MAINTENANCE > C D E F G H I J K L M B MA N O A RADIATOR CAP : Inspection INFOID:0000000003862453 • Check valve seat (A) of radiator cap. plunger (B) cannot be seen when watching it vertically from the - Check if valve seat has no soil and damage. cap negative-pressure valve. - Check that there are no unusualness in the opening and closing conditions of negative-pressure valve. • Check radiator cap relief pressure. - When connecting radiator cap to the radiator cap tester (commer- cial service tool) and the radiator cap tester adapter (commercial • Replace radiator cap if there is an unusualness related to the above three. CAUTION: When installing radiator cap, thoroughly wipe out the radiator pipe (upper) filler neck to remove any RADIATOR RADIATOR : Inspection INFOID:0000000003862454 Check radiator for mud or clogging. If necessary, clean radiator as follows: CAUTION: • Be careful not to bend or damage radiator fins. assembly and horns. Then tape harness and connectors to prevent water from entering. 1. Apply water by hose to the back side of the radiator core vertically downward. 2. Apply water again to all radiator core surfaces once per minute. 3. Stop washing if any stains no longer flow out from radiator. 4. Blow air into the back side of radiator core vertically downward. 2 , 71 psi) and keep distance more than 30 cm (11.81 in). 5. Blow air again into all the radiator core surfaces once per minute until no water sprays out. FUEL LINES JPBIA1961ZZ Standard and limit : Refer to . JPBIA0109ZZ |