|
|
EXL-230 < COMPONENT DIAGNOSIS > [HALOGEN TYPE] HEADLAMP (LO) CIRCUIT Does continuity exist? YES >> GO TO 5. NO >> Repair the harnesses or connectors. 3. CHECK HEADLAMP (LO) FUSE 1. Turn the ignition switch OFF. 2. Check that the following fuses are not fusing. Is the fuse fusing? YES >> GO TO 4. NO >> Replace IPDM E/R. 4. CHECK HEADLAMP (LO) SHORT CIRCUIT 1. Disconnect IPDM E/R connector. 2. Check continuity between the IPDM E/R harness connector and the ground. Does continuity exist? YES >> Repair the harnesses or connectors. And then replace the fuse. NO >> Replace the fuse. (Replace IPDM E/R if the fuse is fusing again.) 5. CHECK HEADLAMP (LO) GROUND OPEN CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect the front combination lamp connector. 3. Check continuity between the front combination lamp harness connector and ground. Does continuity exist? YES >> Replace the headlamp (LO) bulb. (Bulb socket is abnormally.) NO >> Repair the harnesses or connectors. Unit Lotion Fuse No. Capacity Headlamp LO (RH) IPDM E/R #57 15 A Headlamp LO (LH) IPDM E/R #56 15 A IPDM E/R Ground Continuity Connector Terminal RH E345 83 Not existed LH 84 Front combination lamp Ground Continuity Connector Terminal RH E319 4 Existed LH E318 4 |