Nissan Murano Z51. Manual - part 942

INT-38

< REMOVAL AND INSTALLATION >

BACK DOOR TRIM

BACK DOOR TRIM

Exploded View

INFOID:0000000005513301

Removal and Installation

INFOID:0000000005513302

REMOVAL

BACK DOOR FINISHER INNER

1.

Fully open back door.

2.

Disengage pull handle finisher (1) fixing pawls with remover tool
(A) and then remove pull handle finisher.

1.

Auto power back door switch finisher 2.

Back door finisher inner 

3.

Pull handle finisher

4.

Back door finisher lid

5.

Back door assembly

6.

Back door plate

7.

Back door hinge cover

: Clip

: Pawl

: Metal clip

JMJIA1382ZZ

: Pawl

JMJIA0621ZZ

BACK DOOR TRIM

INT-39

< REMOVAL AND INSTALLATION >

C

D

E

F

G

H

I

K

L

M

A

B

INT

N

O

P

3.

Push the clip center with a wrapped flat-blade screwdriver (B)
and then remove clip (A).

4.

Disengage the luggage room lamp fixing pawls with a tool, dis-
connect the harness connector (A) then remove the lamp (1)
(LH/RH)

5.

Disengage the back door finisher lid (1) fixing pawls, then
remove the back door finisher lid with remover tool (A).

6.

Remove the auto power back door switch finisher (1) by using a
remover tool (A) and then remove auto power door switch fin-
isher.

7.

Remove the back door finisher inner.
NOTE:
It is strongly recommended to follow the steps below when removing the back door finisher. Failing doing
so may cause the damage of the clips. 

JMJIA1018ZZ

JMJIA1385ZZ

: Pawl

JMJIA1384ZZ

: Pawl

JMJIA1383ZZ

INT-40

< REMOVAL AND INSTALLATION >

BACK DOOR TRIM

1.

Insert remover tool (A) between back door finisher inner (1)
and back door panel to disengage the metal clips (LH/RH).

2.

Insert remover tool (A) between back door finisher inner (1)
and back window glass, pull downwards to disengage clips
as shown in the figure.

3.

Insert remover tool (A) between back door lower finisher
inner (1) and back door panel to disengage the clips.
NOTE:
Starting from the lower downwards and works around the
edges and up to the sides.

8.

Pull out to remove back door finisher inner.

9.

Disengage back door plate (1) fixing pawls and metal clips with
remover tool (A) and then remove back door plate.

: Metal clip

JMJIA1673ZZ

: Clip

: Metal clip

JMJIA1674ZZ

: Clip

JMJIA0622ZZ

: Pawl

: Metal clip

JMJIA1691ZZ

BACK DOOR TRIM

INT-41

< REMOVAL AND INSTALLATION >

C

D

E

F

G

H

I

K

L

M

A

B

INT

N

O

P

10. Disengage back door hinge cover (1) fixing clips with remover

tool (A) and then remove back door hinge cover (LH/RH).

INSTALLATION

Install in the reverse order of removal.

CAUTION:

When installing back door trim, check that clips are securely fitted in panel holes on body, and then
press them in.

: Clip

JMJIA1692ZZ