|
|
FAX-46 < REMOVAL AND INSTALLATION > [AWD] FRONT DRIVE SHAFT 11. Remove drive shaft from link shaft. • Use the drive shaft attachment (A) [SST: KV40107500 ( — )] and a sliding hammer (B) while inserting tip of the drive shaft attachment between housing assembly and link shaft CAUTION: Never place drive shaft joint at an extreme angle when 12. Remove bearing housing mounting bolts. 13. Remove link shaft assembly from support bearing bracket. 14. Remove support bearing bracket, follow the procedure described below. a. Remove front exhaust tube. Refer to b. Remove three way catalyst (bank 1) and heated oxygen sensor harness bracket. Refer to c. Remove support bearing bracket. INSTALLATION Note the following, and install in the reverse order of removal. . • Place the protector (A) [SST: KV38107900 ( — )] onto transaxle assembly to prevent damage to the oil seal while inserting lonk • Install support bearing bracket (1) in following procedure, fied torque. - Temporarily tighten mounting bolts (B), then tighten them to speci- fied torque. • Apply NISSAN genuine grease to drive shaft serration (link shaft side), and install drive shaft onto link shaft. • Clean the matching surface of wheel hub lock nut and wheel hub and bearing assembly. CAUTION: Never apply lubricating oil to these matching surface. • Clean the matching surface of drive shaft and wheel hub and bearing assembly. CAUTION: JPDIF0004ZZ JPDIF0147ZZ JPDIF0143ZZ Standard : 1.5 – 2.5 g (0.053 – 0.088 oz) Revision: 2011 November 2011 MURANO |