|
|
содержание .. 1842 1843 1844 1845 ..
B26E8 CLUTCH INTERLOCK SWITCH SEC-143 < DTC/CIRCUIT DIAGNOSIS > [WITH INTELLIGENT KEY SYSTEM] C D E F G H I J L M A B SEC N O P B26E8 CLUTCH INTERLOCK SWITCH DTC Description INFOID:0000000010922178 DTC DETECTION LOGIC POSSIBLE CAUSE • Harness or connector (Clutch pedal position switch circuit is open or shorted) • Harness or connector (Clutch interlock switch circuit is open or shorted) • Clutch interlock switch FAIL-SAFE — DTC CONFIRMATION PROCEDURE 1. PERFORM DTC CONFIRMATION PROCEDURE 1 1. Turn ignition switch ON. 2. Wait 2 seconds or more under the following conditions. - Shift lever: In the neutral position. - Clutch pedal: Depressed 3. Select “Self Diagnostic Result” mode of “BCM” using CONSULT. Is DTC detected? YES >> Refer SEC-143, "Diagnosis Procedure" NO >> GO TO 2. 2. PERFORM DTC CONFIRMATION PROCEDURE 2 1. Release clutch pedal and wait 2 seconds or more. 2. Select “Self Diagnostic Result” mode of “BCM” using CONSULT. Is DTC detected? YES >> Refer to SEC-143, "Diagnosis Procedure" NO-1 >> To check malfunction symptom before repair: Refer to GI-44, "Intermittent Incident" NO-2 >> Confirmation after repair: INSPECTION END Diagnosis Procedure INFOID:0000000010922179 1. CHECK FUSE 1. Turn ignition switch OFF. 2. Check that the following fuse in the fuse block (J/B) is not blown. Is the inspection result normal? YES >> GO TO 2. NO >> Replace the blown fuse after repairing the cause of blowing. 2. CHECK CLUTCH INTERLOCK SWITCH POWER SUPPLY 1. Disconnect clutch interlock switch connector. 2. Check voltage between clutch interlock switch harness connector and ground. DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B26E8-00 CLUTCH SW BCM detects that clutch pedal position switch is also ON for 2sec Signal name Fuse No. Battery power supply 8 (5 A) |