|
|
STC-44 < SYMPTOM DIAGNOSIS > UNBALANCE STEERING WHEEL TURNING FORCE (TORQUE VARIATION) UNBALANCE STEERING WHEEL TURNING FORCE (TORQUE VARIA- Description INFOID:0000000010452142 Unbalance steering wheel turning force (torque variation). Diagnosis Procedure INFOID:0000000010452143 1. PERFORM SELF-DIAGNOSIS With CONSULT 1. Turn the ignition switch OFF to ON. 2. Perform “EPS/DAST 3” self-diagnosis. Is any DTC detected? YES >> Check the DTC. Refer to NO >> GO TO 2. 2. CHECK THE ILLUMINATION OF THE POWER STEERING WARNING LAMP Check the power steering warning lamp while the engine is started. Does the power steering warning lamp turn OFF? YES >> GO TO 3. NO >> Refer to . 3. CHECK STEERING COLUMN AND STEERING GEAR Check the steering column assembly and steering gear assembly. • Steering gear assembly. Refer to . Is the inspection result normal? YES >> GO TO 4. NO >> Repair or replace the specific malfunctioning part. 4. CHECK EPS CONTROL UNIT SIGNAL (1) With CONSULT 1. Start the engine. CAUTION: Never drive the vehicle. 2. Select “ASSIST LEVEL” in “DATA MONITOR” in “EPS/DAST 3”. Dose the item in “DATA MONITOR” maintain “100%”? YES >> GO TO 7. NO >> GO TO 5. 5. CHECK EPS CONTROL UNIT SIGNAL (2) With CONSULT Select “BATTERY VOLT” in “DATA MONITOR” in “EPS/DAST 3”. Dose the item in “DATA MONITOR” indicate “10.5 V” or more? YES >> GO TO 6. NO >> Perform trouble diagnosis of EPS control unit power supply and ground. Refer to . 6. CHECK EPS CONTROL UNIT SIGNAL (3) With CONSULT 1. Select “ASSIST LEVEL” in “DATA MONITOR” in “EPS DAST 3”. 2. Stop the EPS system until the item in “DATA MONITOR” becomes “100%”. 3. Check that the symptom continues. Dose the symptom continue? |