|
|
PB-106 < DTC/CIRCUIT DIAGNOSIS > C1BDB PARKING BRAKE ACTUATOR RIGHT Is the inspection result normal? YES >> GO TO 5. NO >> Repair or replace error-detected parts, and GO TO 5. 5. CHECK CONNECTOR AND TERMINAL Check the electric parking brake control module pin terminals for damage or loose connection with harness Is the inspection result normal? YES >> GO TO 6. NO >> Repair or replace error-detected parts, and GO TO 6. 6. PERFORM SELF-DIAGNOSIS With CONSULT 1. Connect the electric parking brake control module harness connector. 2. Turn the ignition switch ON. 3. Erase self-diagnosis result for “EHS/PKB”. 4. Repeat the parking brake switch operation (pull and push) five times. 5. Perform self-diagnosis for “EHS/PKB”. Is DTC “C1BDB (CIRC CRRNT BELOW THRESHOLD)” detected? YES >> Replace the electric parking brake control module. Refer to PB-141, "Removal and Installation" NO >> INSPECTION END TYPE 5 TYPE 5 : Diagnosis Procedure INFOID:0000000010833693 1. CHECK PARKING BRAKE ACTUATOR CIRCUIT 1. Parking brake switch operation (pull and push). 2. Turn the ignition switch OFF. 3. Disconnect the electric parking control module harness connector. 4. Check the continuity between electric parking brake control module harness connector terminals. Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace error-detected parts, and GO TO 2. 2. CHECK ELECTRIC PARKING BRAKE CONTROL MODULE IGNITION POWER SUPPLY 1. Check the voltage between electric parking brake control module harness connector and ground. 2. Turn the ignition switch ON. 3. Check the voltage between electric parking brake control module harness connector and ground. Electric parking brake control module — Continuity Connector Terminal M29 28 Ground Existed 30 Electric parking brake control module Continuity Connector Terminal M29 12 − 27 Existed Electric parking brake control module — Voltage Connector Terminal M29 13 Ground 9 − 16 V |