|
|
DIAGNOSIS SYSTEM (ECM) EC9-67 < SYSTEM DESCRIPTION > [R9M] C D E F G H I J K L M A EC9 N P O *: The items are the same as those of 1st trip freeze frame data. DATA MONITOR MODE NOTE: WATER IN DIESEL DETEC- Water in diesel detector — • NOT DETECTED WATER PUMP RELAY COM- Water pump relay command — • DEACTIVAT CONFIRMED FAILURE Confirmed failure corresponding to the — • FRAME ABSENT Item * Unit Remarks CONSULT screen terms Full spell Monitor item Unit Description Remarks INLET AIR TEMPERATURE ° C or ° F Intake air temperature is displayed. BOOST PRESSURE mbar Turbocharger boost pressure is displayed. TEMP UPSTREAM TURBINE ° C or ° F Exhaust gas temperature computed from exhaust gas tem- ATOMOS PRESS mbar Atmospheric pressure is displayed. WATER TEMP ° C or ° F Engine coolant temperature is displayed. COMP SUP VOLT V The power supply voltage of ECM is displayed. ENGINE SPEED rpm Engine speed computed from crankshaft position sensors VEHICLE SPEED km/h or mph The vehicle speed computed from the vehicle speed sig- MEASURE AIR FLOW kg/h Intake air flow rate computed from the mass air flow sensor RAIL PRESSURE bar Fuel rail pressure is displayed. RAIL PRES SET bar Target fuel rail pressure is displayed. UPS PRTCL FLTR TMP ° C or ° F Exhaust gas temperature before DPF computed from the FUEL FLOW S/V CURRENT mA Current value of fuel flow actuator is displayed. LAST OFF/V CLOSE % Inlet throttle valve offset - last closed learning IN FLAP ABSO POSI % Raw value of the position in percent of the sensor supply FIRST OFF/V OPEN % Inlet throttle valve offset - first opened learning FIRST OFF/V CLOSE % Inlet throttle valve offset - first closed learning LAST OFF/V OPEN % Inlet throttle valve offset - last opened learning REGENERATION FAIL — Indicates the number of DPF regeneration failures since FLOW GAS IN DPF m3/h Flow of gas inside the DPF is displayed. DPF INJEC RC COM % 5th injector PWM command POST INJEC FLOW 1 mg/cp Post injection quantity is displayed. |