|
|
ECK-168 < DTC/CIRCUIT DIAGNOSIS > [K9K] B1900 DC/DC CONVERTER B1900 DC/DC CONVERTER DTC Logic INFOID:0000000010289730 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PRECONDITIONING If the other DTC Confirmation Procedure is performed right before this procedure, the ignition switch must be >> GO TO 2. 2. PERFORM DTC CONFIRMATION PROCEDURE-1 1. Turn ignition switch ON and wait at least 3 seconds. 2. Check DTC. Is DTC detected? YES >> Proceed to ECK-168, "Diagnosis Procedure" NO >> GO TO 3. 3. PERFORM DTC CONFIRMATION PROCEDURE-2 With CONSULT 1. Start the engine and warm it up to normal operating temperature. 2. Press start/stop OFF switch and check that the switch indicator is ON. 3. Select “AUTO STOP START” in “ACTIVE TEST” mode of “ENGINE” using CONSULT. 4. Touch “START” and operate stop/start system. (engine stop.) 5. Touch “CANCEL” and restart the engine. 6. Check DTC. Without CONSULT 1. Activate stop/start system. Refer to ECK-39, "STOP/START SYSTEM : System Description" CAUTION: Always drive vehicle at a safe speed. 2. Restart the engine. 3. Check DTC. Is DTC detected? YES >> Proceed to ECK-168, "Diagnosis Procedure" NO >> INSPECTION END Diagnosis Procedure INFOID:0000000010289731 1. CHECK FUSIBLE LINK 1. Turn ignition switch OFF. 2. Check that the following fusible link is not fusing. Is the fusible link fusing? YES >> Replace the fusible link after repairing the applicable circuit. DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause B1900 DC/DC CONVERTER DC/DC converter detects power supply • Harness and connectors (DC/DC converter power supply input 1 cir- • DC/DC converter Location Fusible link Capacity Fusible link holder O 30 A |