|
|
ECH-242 < DTC/CIRCUIT DIAGNOSIS > [HRA2DDT] P0638 ELECTRIC THROTTLE CONTROL ACTUATOR FUNCTION P0638 ELECTRIC THROTTLE CONTROL ACTUATOR FUNCTION DTC Logic INFOID:0000000010379135 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PRECONDITIONING Turn ignition switch OFF and wait at least 12 minutes. >> GO TO 2. 2. PERFORM DTC CONFIRMATION PROCEDURE 1. Start engine and run engine at idle speed for at least 10 second. 2. Check DTC. Is DTC detected? YES >> Proceed to ECH-242, "Diagnosis Procedure" NO >> INSPECTION END Diagnosis Procedure INFOID:0000000010379136 1. CHECK ECM HARNESS CONNECTOR CONNECTION 1. Turn ignition switch OFF. 2. Check ECM connector connection. Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace error-detected parts. 2. CHECK ELECTRIC THROTTLE CONTROL ACTUATOR HARNESS CONNECTOR CONNECTION Check electric throttle control actuator harness connector connection. Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace error-detected parts. 3. CHECK ELECTRIC THROTTLE CONTROL ACTUATOR POWER SUPPLY CIRCUIT-1 1. Disconnect electric throttle control actuator harness connector. 2. Turn ignition switch ON. 3. Check the voltage between electric throttle control actuator harness connector terminals. Is the inspection result normal? YES >> GO TO 4. NO >> GO TO 8. 4. CHECK THROTTLE POSITION SENSOR CIRCUIT 1. Turn ignition switch OFF. DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0638 THROTTLE ACTUATOR B1 The value of electric throttle control actuator Electric throttle control actuator Electric throttle control actuator Voltage (Approx.) Connector + - Terminal Terminal F46 5 3 5.0 V |