|
|
Content .. 2069 2070 2071 2072 ..
SN-78 < BASIC INSPECTION > [WITH PARKING SPACE MEASUREMENT] INSPECTION AND ADJUSTMENT CONFIGURATION (SONAR CONTROL UNIT) : Description INFOID:0000000010478031 Vehicle specification needs to be written with CONSULT. Configuration has three functions as follows: CAUTION: • When replacing sonar control unit, you must perform “Select Saved Data List” or "After Replace ECU" with CONSULT. • Complete the procedure of “Select Saved Data List” or "After Replace ECU" in order. CONFIGURATION (SONAR CONTROL UNIT) : Work Procedure INFOID:0000000010478032 1. WRITING MODE SELECTION CONSULT Select “Reprogramming, Configuration” of sonar control unit. When writing saved data>>GO TO 2. 2. PERFORM “SAVED DATA LIST” CONSULT Automatically “Operation Log Selection” window will display if “Before Replace ECU” was performed. Select >> Work End. 3. PERFORM “AFTER REPLACE ECU” OR “MANUAL CONFIGURATION” CONSULT 1. Select “After Replace ECU” or “Manual Configuration”. 2. Identify the correct model and configuration list. Refer to SN-79, "CONFIGURATION (SONAR CONTROL 3. Confirm and/or change setting value for each item. CAUTION: Thoroughly read and understand the vehicle specification. ECU control may not operate normally 4. Select “Next”. CAUTION: Make sure to select “Next”, confirm each setting value and press “OK” even if the indicated con- 5. When "Completed", select "End". >> GO TO 4. 4. OPERATION CHECK Confirm that each function controlled by sonar control unit operates normally. >> Work End. Function Description "Before Replace ECU" • Reads the vehicle configuration of current sonar control unit. "After Replace ECU" Writes the vehicle configuration with manual selection. "Select Saved Data List" Writes the vehicle configuration with saved data. |