|
|
Content .. 1828 1829 1830 1831 ..
BCS-46 < SYSTEM DESCRIPTION > DIAGNOSIS SYSTEM (BCM) * 1 : It is displayed but does not operate on CVT models. * 2 : OFF is displayed when brake pedal is depressed while brake switch power supply is OFF. ACTIVE TEST S/L OPERATION PRHBT (SPD) Indicates [On/Off] condition of vehicle speed signal S/L OPERATION PRHBT (PWR) Indicates [Allowed/Forbid] condition of safety line inhibition S/L SENSOR POWER (CAN) Indicates [On/Off] condition of sensor test power supply S/L SEN TEST PERMIT (CAN) Indicates [Forbid/Authorize] condition of sensor test S/L STAT NOT DETECT (CAN) Indicates [Ok/Undefind] condition of steering lock undefined position signal S/L LOCKING FINISHED (CAN) Indicates [Unfinshd/Finished] condition of steering lock unit lock status signal STOP/START SW Indicates [On/Off] condition of stop/start off switch RKE-LOCK Indicates [On/Off] condition of LOCK signal from Intelligent Key RKE-UNLOCK Indicates [On/Off] condition of UNLOCK signal from Intelligent Key RKE-TR/BD NOTE: RKE-PANIC NOTE: RKE-MODE CHG Indicates [On/Off] condition of MODE CHANGE signal from Intelligent Key RKE PBD NOTE: KEY SW NOTE: IGN SW NOTE: START SW NOTE: Monitor Item Condition Test item Description OUTSIDE BUZZER This test is able to check Intelligent Key warning buzzer operation INSIDE BUZZER This test is able to check warning chime in combination meter operation touched • Buzzer 3: Combination meter buzzer sounds (pipipipi-pipipipi-...) when CONSULT screen is touched • Off: Non-operation INDICATOR This test is able to check warning lamp operation FLASHER This test is able to check security hazard lamp operation HORN NOTE: IGN CONT2 This test is able to operate the blower relay in fuse block (J/B) MIRROR +5 NOTE: ENGINE SW ILLUMI This test is able to check push-ignition switch illumination operation |