|
|
Content .. 1028 1029 1030 1031 ..
SRC-58 < DTC/CIRCUIT DIAGNOSIS > B0094 CRASH ZONE SENSOR • Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.) • Never use unspecified tester or other measuring device. 1. CHECK DTC Perform each inspection according to the displayed DTC. [B0094–86]>> GO TO 4. 2. CHECK HARNESS CONNECTOR Check the harness connector. Is the inspection result normal? YES >> GO TO 3. NO >> Replace harness connector. 3. CHECK WIRING HARNESS Check the wiring harness externals. Is the inspection result normal? YES >> GO TO 4. NO >> Replace wiring harness. 4. REPLACE CRASH ZONE SENSOR 1. Replace crash zone. Refer to SR-24, "Removal and Installation" 2. Perform DTC confirmation procedure. Refer to . Is DTC detected? YES >> GO TO 5. NO >> INSPECTION END 5. REPLACE AIR BAG DIAGNOSIS SENSOR UNIT 1. Replace air bag diagnosis sensor unit. Refer to SR-28, "Removal and Installation" 2. Perform DTC confirmation procedure. Refer to . Is DTC detected? YES >> GO TO 1. NO >> INSPECTION END |