|
|
P2138 APP SENSOR EC-1153 < DTC/CIRCUIT DIAGNOSIS > [MR EXCEPT FOR NISMO RS MODELS] C D E F G H I J K L M A EC N P O P2138 APP SENSOR DTC Logic INFOID:0000000012198678 DTC DETECTION LOGIC NOTE: If DTC P2138 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to . DTC CONFIRMATION PROCEDURE 1. PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Turn ignition switch OFF and wait at least 10 seconds. TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is more than 8 V at idle. >> GO TO 2. 2. PERFORM DTC CONFIRMATION PROCEDURE 1. Start engine and let it idle for 1 second. 2. Check DTC. YES >> Proceed to EC-1153, "Diagnosis Procedure" NO >> INSPECTION END Diagnosis Procedure INFOID:0000000012198679 1. CHECK APP SENSOR 1 POWER SUPPLY 1. Turn ignition switch OFF. 2. Disconnect accelerator pedal position (APP) sensor harness connector. 3. Turn ignition switch ON. 4. Check the voltage between APP sensor harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> GO TO 2. 2. CHECK APP SENSOR 1 POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. DTC No. Trouble diagnosis name (Trouble diagnosis con- tent) DTC detecting condition Possible cause P2138 APP SENSOR Rationally incorrect voltage is sent to ECM • Harness or connector (APP sensor 1 or 2 circuit is open or • Accelerator pedal position sensor (APP sensor 1 or 2) • Sensor power supply 2 circuit + − Voltage (Approx.) APP sensor Connector Terminal E101 4 Ground 5 V |