Nissan Juke F15. Manual - part 269

 

  Index      Nissan     Nissan Juke F15 (2015 year) - Service and Repair Manual

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  267  268  269  270   ..

 

 

Nissan Juke F15. Manual - part 269

 

 

AWD MODE INDICATOR LAMP (AWD)

DLN-81

< DTC/CIRCUIT DIAGNOSIS >

[TRANSFER: TY21B]

C

E

F

G

H

I

J

K

L

M

A

B

DLN

N

O

P

AWD MODE INDICATOR LAMP (AWD)

Component Function Check

INFOID:0000000012199440

1.

AWD MODE INDICATOR LAMP OPERATION CHECK

Check that AWD mode indicator lamp (AWD) turns on for approximately 1 second after the ignition switch is

turned ON.
Is the inspection result normal?

YES

>> INSPECTION END

NO

>> Proceed to 

DLN-81, "Diagnosis Procedure"

.

Diagnosis Procedure

INFOID:0000000012199441

1.

CHECK AWD WARNING LAMP

1. Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.

2. Stop the vehicle.
Does AWD warning lamp turn ON?

YES

>> Proceed to 

DLN-79, "Diagnosis Procedure"

.

NO

>> GO TO 2.

2.

CHECK AWD MODE SWITCH

Perform the trouble diagnosis for AWD mode switch. Refer to 

DLN-47, "Diagnosis Procedure"

.

Is the inspection result normal?

YES

>> GO TO 3.

NO

>> Repair or replace the error-detected parts.

3.

CHECK AWD MODE INDICATOR LAMP SIGNAL

With CONSULT

1. Start the engine.

CAUTION:

Stop the vehicle.

2. Change AWD mode switch to “AWD” from “AWD-V”.

3. Check “INDICATOR” in “DATA MONITOR” for “ALL MODE AWD/4WD”.
Does the item on “DATA MONITOR” indicate “AWD”?

YES

>> GO TO 4.

NO

>> Replace AWD control module. Refer to 

DLN-91, "Removal and Installation"

.

4.

CHECK COMBINATION METER POWER SUPPLY CIRCUIT

Perform the trouble diagnosis for combination meter power supply circuit. Refer to 

MWI-53, "COMBINATION

METER : Diagnosis Procedure"

.

Is the inspection result normal?

YES

>> INSPECTION END

NO

>> Repair or replace the error-detected parts.

DLN-82

< SYMPTOM DIAGNOSIS >

[TRANSFER: TY21B]

AWD WARNING LAMP DOES NOT TURN ON

SYMPTOM DIAGNOSIS

AWD WARNING LAMP DOES NOT TURN ON

Description

INFOID:0000000012199442

AWD warning lamp does not turn ON when the ignition switch is turned to ON.

Diagnosis Procedure

INFOID:0000000012199443

1.

CHECK AWD WARNING LAMP

Perform the trouble diagnosis for AWD warning lamp. Refer to 

DLN-79, "Diagnosis Procedure"

.

Is the inspection result normal?

YES

>> Check each harness connector pin terminal for malfunction or disconnection.

NO

>> Repair or replace the error-detected parts.

AWD WARNING LAMP DOES NOT TURN OFF

DLN-83

< SYMPTOM DIAGNOSIS >

[TRANSFER: TY21B]

C

E

F

G

H

I

J

K

L

M

A

B

DLN

N

O

P

AWD WARNING LAMP DOES NOT TURN OFF

Description

INFOID:0000000012199444

AWD warning lamp does not turn OFF approx. 1 second after the engine started.

Diagnosis Procedure

INFOID:0000000012199445

1.

PERFORM SELF-DIAGNOSIS

With CONSULT

Perform self-diagnosis for “ALL MODE AWD/4WD”.
Is any DTC detected?

YES

>> Perform trouble diagnosis for detected DTC. Refer to 

DLN-31, "DTC Index"

.

NO

>> GO TO 2.

2.

CHECK AWD WARNING LAMP

Perform the trouble diagnosis of the AWD warning lamp. Refer to 

DLN-79, "Diagnosis Procedure"

.

Is the inspection result normal?

YES

>> GO TO 3.

NO

>> Repair or replace the error-detected parts.

3.

CHECK AWD CONTROL MODULE POWER SUPPLY AND GRAND CIRCUIT

Perform the trouble diagnosis of power supply and ground circuit. Refer to 

DLN-77, "Diagnosis Procedure"

.

Is the inspection result normal?

YES

>> Check each harness connector pin terminal for malfunction or disconnection.

NO

>> Repair or replace the error-detected parts.

DLN-84

< SYMPTOM DIAGNOSIS >

[TRANSFER: TY21B]

HEAVY TIGHT-CORNER BRAKING SYMPTOM OCCURS

HEAVY TIGHT-CORNER BRAKING SYMPTOM OCCURS

Description

INFOID:0000000012199446

Heavy tight-corner braking symptom occurs when the vehicle is driven and the steering wheel is turned fully to

either side after the engine is started.

NOTE:

Light tight-corner braking symptom may occur depending on driving conditions. This is not malfunction.

Diagnosis Procedure

INFOID:0000000012199447

1.

PERFORM ECM SELF-DIAGNOSIS

With CONSULT

Perform self-diagnosis for “ENGINE”.
Is any DTC detected?

YES

>> Perform trouble diagnosis for detected DTC. Refer to 

EC-706, "DTC Index"

 (Except for NISMO

RS), 

EC-115, "DTC Index"

 (For NISMO RS).

NO

>> GO TO 2.

2.

PERFORM SELF-DIAGNOSIS

With CONSULT

Perform self-diagnosis for “ALL MODE AWD/4WD”.
Is any DTC detected?

YES

>> Perform trouble diagnosis for detected DTC. Refer to 

DLN-31, "DTC Index"

.

NO

>> GO TO 3.

3.

CHECK AWD SOLENOID

Perform the trouble diagnosis of the AWD solenoid. Refer to 

DLN-57, "Diagnosis Procedure"

 (Left side), 

DLN-

60, "Diagnosis Procedure"

 (Right side).

Is the inspection result normal?

YES

>> GO TO 4.

NO

>> Repair or replace the error-detected parts.

4.

CHECK ELECTRIC CONTROLLED COUPLING

1. Turn the ignition switch OFF.

2. Set the transaxle to neutral. Release the parking brake.

3. Lift up the vehicle.

4. Rotate the propeller shaft by hand.

5. Hold rear wheel of right and left lightly.
Does rear wheel rotate?

YES

>> Replace electric controlled coupling for mechanical malfunction (clutch sticking etc.). Refer to

DLN-145, "Removal and Installation"

.

NO

>> Check each harness connector pin terminal for disconnection.

 

 

 

 

 

 

 

Content   ..  267  268  269  270   ..