Nissan Juke F15. Manual - part 1172

B0029 CURTAIN AIR BAG MODULE

SRC-53

< DTC/CIRCUIT DIAGNOSIS >

C

D

E

F

G

I

J

K

L

M

A

B

SRC

N

O

P

• Never use unspecified tester or other measuring device. 

1.

CHECK HARNESS CONNECTOR

Check the harness connector for disconnection, looseness or damage.
Is the inspection result normal?

YES

>> GO TO 2.

NO–1 >> Damage: Replace malfunctioning harness and connector.

NO–2 >> Disconnection or looseness: Securely lock the connector.

2.

CHECK WIRING HARNESS

Check the wiring harness externals.
Is the inspection result normal?

YES

>> GO TO 3.

NO

>> Replace malfunctioning harness and connector.

3.

REPLACE CURTAIN AIR BAG MODULE RH

1. Replace curtain air bag module RH. Refer to 

SR-21, "Removal and Installation"

.

2. Perform DTC confirmation procedure. Refer to 

SRC-52, "DTC Description"

.

Is DTC detected?

YES

>> GO TO 4. 

NO

>> INSPECTION END

4.

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

1. Replace air bag diagnosis sensor unit. Refer to 

SR-29, "Removal and Installation"

.

2. Perform DTC confirmation procedure. Refer to 

SRC-52, "DTC Description"

.

Is DTC detected?

YES

>> GO TO 1. 

NO

>> INSPECTION END

SRC-54

< DTC/CIRCUIT DIAGNOSIS >

B0091 B-PILLAR SATELLITE SENSOR

B0091 B-PILLAR SATELLITE SENSOR

DTC Description

INFOID:0000000012199606

DTC DETECTION LOGIC

POSSIBLE CAUSE

[B0091–11]

• Connection malfunction or short circuit to ground of harness and connector

• Internal malfunction of satellite sensor LH

• Internal malfunction of air bag diagnosis sensor unit

[B0091–23, B0091–24, B0091–25, B0091–28]

• Internal malfunction of satellite sensor LH

• Internal malfunction of air bag diagnosis sensor unit

[B0091–81, B0091–93]

• Connection malfunction of harness or connector

• Internal malfunction of satellite sensor LH

• Internal malfunction of air bag diagnosis sensor unit

[B0091–86]

• Air bag diagnosis sensor unit and satellite sensor LH is different from the part specified

[B0091–88]

• Connection malfunction or open circuit of harness and connector

• Internal malfunction of satellite sensor LH

• Internal malfunction of air bag diagnosis sensor unit

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

1.

CHECK SELF-DIAG RESULT

 With CONSULT

1. Turn ignition switch ON.

2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

 Without CONSULT

1. Turn ignition switch ON.

2. Check the air bag warning lamp status. Refer to 

SRC-10, "On Board Diagnosis Function"

.

NOTE:

SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.
Is malfunctioning part detected?

YES

>> Refer to 

SRC-55, "Diagnosis Procedure"

.

NO-1 >> To check malfunction symptom before repair: Refer to 

GI-45, "Intermittent Incident"

.

DTC

CONSULT screen items

(Trouble diagnosis content)

DTC detecting condition

B0091–11

B-PILLAR SAT SEN LH 
[Left Side Restraints 
Sensor 1 (Subfault)]

[GND-SHORT]

Satellite sensor LH circuit is shorted to ground

B0091–23

[LOWER LIMIT ERR]

Lower limit value malfunction of satellite sensor LH

B0091–24

[UPPER LIMIT ERR]

Upper limit value malfunction of satellite sensor LH

B0091–25

[SELF-DIAG ERR]

Diagnosis malfunction of satellite sensor LH

B0091–28

[OFFSET ERR]

Offset malfunction of satellite sensor LH

B0091–81

[COMM ERR]

Communication malfunction of satellite sensor LH

B0091–86

[UNMATCH]

Satellite sensor LH is out of the specified specification

B0091–88

[OPEN]

Satellite sensor LH circuit is open

B0091–93

[RESET]

Reset malfunction of satellite sensor LH

B0091 B-PILLAR SATELLITE SENSOR

SRC-55

< DTC/CIRCUIT DIAGNOSIS >

C

D

E

F

G

I

J

K

L

M

A

B

SRC

N

O

P

NO-2 >> Confirmation after repair: INSPECTION END

Diagnosis Procedure

INFOID:0000000012199607

WARNING:

• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3

minutes or more. (To discharge backup capacitor.)

• Never use unspecified tester or other measuring device. 

1.

CHECK DTC

Perform each inspection according to the displayed DTC.
Which DTC is displayed?

[B0091–86]>>GO TO 4.

Other than the above>>GO TO 2.

2.

CHECK HARNESS CONNECTOR

Check the harness connector for disconnection, looseness or damage.
Is the inspection result normal?

YES

>> GO TO 3.

NO–1 >> Damage: Replace malfunctioning harness and connector.

NO–2 >> Disconnection or looseness: Securely lock the connector.

3.

CHECK WIRING HARNESS

Check the wiring harness externals.
Is the inspection result normal?

YES

>> GO TO 4.

NO

>> Replace malfunctioning harness and connector.

4.

REPLACE SATELLITE SENSOR LH

1. Replace satellite sensor LH. Refer to 

SR-26, "Removal and Installation"

.

2. Perform DTC confirmation procedure. Refer to 

SRC-54, "DTC Description"

.

Is DTC detected?

YES

>> GO TO 5. 

NO

>> INSPECTION END

5.

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

1. Replace air bag diagnosis sensor unit. Refer to 

SR-29, "Removal and Installation"

.

2. Perform DTC confirmation procedure. Refer to 

SRC-54, "DTC Description"

.

Is DTC detected?

YES

>> GO TO 1.

NO

>> INSPECTION END

SRC-56

< DTC/CIRCUIT DIAGNOSIS >

B0093 FRONT DOOR SATELLITE SENSOR LH

B0093 FRONT DOOR SATELLITE SENSOR LH

DTC Description

INFOID:0000000012199608

DTC DETECTION LOGIC

POSSIBLE CAUSE

[B0093–11]

• Connection malfunction or short circuit to ground of harness and connector

• Internal malfunction of front door satellite sensor LH

• Internal malfunction of air bag diagnosis sensor unit

[B0093–23, B0093–24, B0093–25, B0093–28]

• Internal malfunction of front door satellite sensor LH

• Internal malfunction of air bag diagnosis sensor unit

[B0093–81, B0093–93]

• Connection malfunction of harness or connector

• Internal malfunction of front door satellite sensor LH

• Internal malfunction of air bag diagnosis sensor unit

[B0093–86]

• Air bag diagnosis sensor unit and front door satellite sensor LH is different from the part specified

[B0093–88]

• Connection malfunction or open circuit of harness and connector

• Internal malfunction of front door satellite sensor LH

• Internal malfunction of air bag diagnosis sensor unit

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

1.

CHECK SELF-DIAG RESULT

 With CONSULT

1. Turn ignition switch ON.

2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

 Without CONSULT

1. Turn ignition switch ON.

2. Check the air bag warning lamp status. Refer to 

SRC-10, "On Board Diagnosis Function"

.

NOTE:

SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.
Is malfunctioning part detected?

YES

>> Refer to 

SRC-57, "Diagnosis Procedure"

.

NO-1 >> To check malfunction symptom before repair: Refer to 

GI-45, "Intermittent Incident"

.

DTC

CONSULT screen items

(Trouble diagnosis content)

DTC detecting condition

B0093–11

DOOR SATEL SENS LH 
[Left Side Restraints Sen-
sor 3 (Subfault)]

[GND-SHORT]

Front door satellite sensor LH circuit is shorted to ground

B0093–23

[LOWER LIMIT ERR] Lower limit value malfunction of front door satellite sensor LH

B0093–24

[UPPER LIMIT ERR]

Upper limit value malfunction of front door satellite sensor LH

B0093–25

[SELF-DIAG ERR]

Diagnosis malfunction of front door satellite sensor LH

B0093–28

[OFFSET ERR]

Offset malfunction of front door satellite sensor LH

B0093–81

[COMM ERR]

Communication malfunction of front door satellite sensor LH

B0093–93

[RESET]

Reset malfunction of front door satellite sensor LH

B0093–86

[UNMATCH]

Front door satellite sensor LH is out of the specified specification

B0093–88

[OPEN]

Front door satellite sensor LH circuit is open