|
|
Content .. 1087 1088 1089 1090 ..
RF-22 < DTC/CIRCUIT DIAGNOSIS > SUNROOF SWITCH 4. Check continuity between sunroof motor assembly harness connector and ground. Is the inspection result normal? YES >> Replace sunroof motor assembly. Refer to RF-37, "Removal and Installation" NO >> Repair or replace harness or connector. 5. CHECK SUNROOF SWITCH Check sunroof switch. . Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-45, "Intermittent Incident" . NO >> Replace sunroof switch (built in map lamp assembly). Refer to RF-45, "Removal and Installation" . Component Inspection INFOID:0000000012196970 SUNROOF SWITCH 1. CHECK SUNROOF SWITCH 1. Turn ignition switch OFF. 2. Disconnect sunroof switch harness connector. 3. Check continuity sunroof switch terminals. Is the inspection result normal? YES >> INSPECTION END NO >> Replace sunroof switch. Refer to RF-45, "Removal and Installation" Sunroof motor assembly Sunroof switch Continuity Connector Terminal Connector Terminal R11 5 R5 1 Existed 10 3 Sunroof motor assembly Ground Continuity Connector Terminal R11 5 Not existed 10 Terminals Condition Continuity 1 2 Sunroof switch is operated TILT DOWN or SLIDE OPEN Existed Other than above Not existed 3 Sunroof switch is operated TILT UP or SLIDE CLOSE Existed Other than above Not existed |