Mitsubishi Outlander XL. Manual - part 682
Q:Is the check result normal?
YES:
Go to Step 3.
NO:
Repair the CAN bus lines. (Refer to GROUP 54D - CAN
Bus Diagnostics table P.54D-17.) On completion, go to
Step 2.
STEP 2. Diagnostic trouble code recheck after resetting
CAN bus lines
Q:Is DTC C1242 set?
YES:
Go to Step 3.
NO:
The procedure is complete.
STEP 3. Check the wheel speed sensor-related diagnostic
trouble code.
Use scan tool to check whether the wheel speed sensor-related
diagnostic trouble code is set or not.
Q:Is any DTC set?
YES:
Troubleshoot for the relevant diagnostic trouble
NO:
Go to Step 4.
STEP 4. G and yaw rate sensor check
Check that the G and yaw rate sensor is installed correctly.
Q:Is the check result normal?
YES:
Go to Step 5.
NO:
Reinstall the G and yaw rate sensor correctly.
STEP 5. M.U.T.-III data list
Check the following service data.
｠
Item 09: G sensor
Q:Is the check result normal?
YES:
Go to Step 6.
NO:
Replace the G and yaw rate sensor, and then go to
Step 6.
STEP 6. Check whether the diagnostic trouble code is reset.
Q:Is DTC C1242 set?
YES:
Replace the ASC-ECU.
NO:
The procedure is complete.
DTC C123C: Abnormality in G and yaw rate sensor (lateral G and yaw rate sensor)
M13506100060USA0000010000
If there is any problem in the CAN bus lines, an incorrect
diagnostic trouble code may be set. Prior to this diagnosis,
diagnose the CAN bus lines. (Refer to GROUP 54D, Trouble
code diagnosis P.54D-17).
ACTIVE SKID CONTROL SYSTEM (ASC)
35C-135
DIAGNOSIS