Mitsubishi Space Star. Manual - part 92

ENGINE COOLING – Radiator <F9Q1>

14-11

REMOVAL SERVICE POINT



A



RADIATOR UPPER HOSE/RADIATOR LOWER
HOSE DISCONNECTION

After making mating marks on the radiator hose and the hose
clamp, disconnect the radiator hose.

INSTALLATION SERVICE POINT



A



RADIATOR LOWER HOSE/RADIATOR UPPER
HOSE CONNECTION

1.

Insert each hose as far as the projection of the water
inlet fitting.

2.

Align the mating marks on the radiator hose and hose
clamp, and then connect the radiator hose.

NOTES

15-1

INTAKE AND

EXHAUST

CONTENTS

GENERAL

2

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

SERVICE SPECIFICATION

2

. . . . . . . . . . . . . . . . . . 

SPECIAL TOOL

2

. . . . . . . . . . . . . . . . . . . . . . . . . . . . 

ON-VEHICLE SERVICE <F9Q1>

2

. . . . . . . . . . . . . 

Waste Gate Actuator Check

2

. . . . . . . . . . . . . . . . . . . 

Turbocharger Waste Gate Solenoid Check

3

. . . . . . 

AIR CLEANER <F9Q1>

4

. . . . . . . . . . . . . . . . . . . . . 

INTERCOOLER <F9Q1>

5

. . . . . . . . . . . . . . . . . . . . . 

INTAKE MANIFOLD <4G93-GDI>

6

. . . . . . . . . . . . . 

INTAKE MANIFOLD <4G13-MPI>

7

. . . . . . . . . . . . . 

INTAKE MANIFOLD AND EXHAUST MANIFOLD
<F9Q1>

8

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

EXHAUST MANIFOLD <4G13-MPI>

9

. . . . . . . . . . 

TURBOCHARGER <F9Q1>

10

. . . . . . . . . . . . . . . . 

EXHAUST PIPE AND MAIN MUFFLER

11

. . . . . 

INTAKE AND EXHAUST – 

General/Service Specification/
Special Tool/On-vehicle Service <F9Q1>

15-2

GENERAL

OUTLINE OF CHANGES



The service procedures have been established due to the adoption of the intake manifold made of
resin for the 4G93-GDI engine and the change of the exhaust pipe.



The service procedures have been established due to the adoption of the intake manifold made of
steel pipe for the 4G13-MPI engine and the exhaust manifold incorporated with the catalytic converter.



The service procedures have been established due to the introduction of the F9Q1 diesel engine.

Other service procedures are the same as before. 

SERVICE SPECIFICATION

Item

Standard value

Turbocharger waste gate solenoid coil resistance 

Ω

 (at 25



C)

15.5 – 17.5

SPECIAL TOOL

Tool

Number

Name

Use

MD998770

Oxygen sensor
wrench

Removal/Installation of oxygen sensor

ON-VEHICLE SERVICE <F9Q1>

WASTE GATE ACTUATOR CHECK

1.

Disconnect the vacuum hose from the waste gate actuator
nipple.

2.

Connect a hand vacuum pump to the nipple.

3.

Check the rod for smooth movement as vacuum pressure
is gradually applied.