|
|
GDI – Troubleshooting 13A-19 OK Measure at air flow sensor Use the test harness Ignition switch: ON Voltage between terminal 6 and C: 3.2 – 3.8 V C: 2.3 – 2.9 V C: 1.5 – 2.1 V C: 0.4 – 1.0 V NG Check the following connectors: NG Repair OK Check the harness between the air OK Check the trouble symptoms. NG Replace the engine-ECU <M/T> or From the previous page Code No. P0115 Engine coolant temperature sensor Probable cause Range of Check Engine: Two seconds after the engine has been started Set Conditions The sensor output voltage is 4.6 V or more for four seconds (equivalent to C of engine coolant temperature) or The sensor output voltage is 0.1 V or less for four seconds (equivalent to C of engine coolant temperature) Malfunction of engine coolant temperature sensor Open or short circuit in the engine coolant Malfunction of engine-ECU <M/T> Malfunction of engine-A/T-ECU <A/T> Range of Check Engine: After starting Set Conditions The engine coolant temperature has reduced from over 40 C to less than 40 C, and that condition has lasted for five minutes or more. |