Mitsubishi Lancer Evolution X. Manual - part 594
DIAGNOSIS <TC-SST>
TSB Revision
TWIN CLUTCH- SPORTRONIC SHIFT TRANSMISSION (TC-SST)
22C-333
STEP 3. Check whether the DTC is reset.
After 15 seconds with the engine idle status, check that the
DTC is reset.
Q: Is DTC No. U0121 set?
YES : Replace the mechatronic assembly. (Refer to
.)
NO : Intermittent malfunction. (Refer to GROUP 00 − How
to Cope with Intermittent Malfunction
.)
DTC U0136: AWC Time-out Error
CAUTION
• If there is any problem in the CAN bus lines,
an incorrect diagnostic trouble code may be
set. Prior to this diagnosis, diagnose the CAN
bus lines.
• Whenever the ECU is replaced, ensure that
the CAN bus lines are normal.
.
DESCRIPTIONS OF MONITOR METHODS
The periodic communication data from the engine
control module cannot be received.
.
PROBABLE CAUSES
• The CAN bus line is defective.
• Malfunction of AWC-ECU
• Malfunction of TC-SST-ECU
DIAGNOSTIC PROCEDURE
Required Special Tools:
• MB991958 Scan Tool (M.U.T.-III Sub Assembly)
• MB991824: Vehicle Communication Interface (V.C.I.)
• MB991827 M.U.T.-III USB Cable
• MB991910 M.U.T.-III Main Harness A
STEP 1. Scan tool CAN bus diagnostics
Using the scan tool, diagnose the CAN bus lines.
Q: Is the check result normal?
YES : Go to Step 2.
NO : Repair the CAN bus lines. (Refer to GROUP 54C −
Troubleshooting
.)
STEP 2. Scan tool diagnostic trouble code
Check the AWC diagnostic trouble code. (Refer to GROUP 22A
− Troubleshooting
Q: Is the DTC set?
YES : Perform the relevant troubleshooting.
NO : Go to Step 3.