|
|
DIAGNOSIS TSB Revision ACTIVE STABILITY CONTROL SYSTEM (ASC) 35C-85 STEP 7. Check of wheel speed detection encoder YES : Go to Step 8. so as not to disturb the magnetization pattern on the NO (Deformation) : Replace the rear wheel hub assembly. (Refer to GROUP 27 − Rear Axle Hub Assembly .) STEP 8. Check whether the DTC is reset. NOTE: The ABS warning light does not turn OFF in some Q: Is DTC C1035 set? YES : Replace the hydraulic unit (incorporates in .) Then go to Step 9. NO : Intermittent malfunction. (Refer to GROUP 00 − How to Cope with Intermittent Malfunction .) STEP 9. Check whether the DTC is reset. NOTE: The ABS warning light does not turn OFF in some Q: Is DTC C1035 set? YES : Return to Step 1. DTC C1041: Abnormality in periodical signal for FL wheel speed sensor CAUTION • If there is any problem in the CAN bus lines, an incor- rect diagnostic trouble code may be set. Prior to this • Whenever the ECU is replaced, ensure that the CAN bus lines are normal. • When the hydraulic unit (integrated with ASC-ECU) is replaced, always perform the calibration of steering .) . AC608248AB Magnetic Rear Wheel Rear wheel |