|
|
ON-VEHICLE SERVICE POWER STEERING 37-18 FLUID REPLACEMENT M1372002100366 1. Raise and support the front wheels. vinyl hose to the return hose, and drain the fluid into a 3. Disconnect the ignition coil connectors (refer to GROUP 16, Ignition Coil, 4. While operating the starter motor intermittently, turn the steering wheel all the way to the left and right several times 5. Connect the return hose securely, and then secure with the clip. 6. Fill the oil reservoir with GENUINE MITSUBISHI POWER STEERING FLUID up to the lower mark of the reservoir, and POWER STEERING SYSTEM AIR BLEEDING M1372002200352 Perform air bleeding procedure as necessary after replacing 2. Disconnect the ignition coil connectors (Refer to GROUP 16, Ignition Coil, CAUTION Perform air bleeding only while cranking the engine. Do or six times while using the starter motor to crank the engine 4. Connect the ignition coil connectors (Refer to GROUP 16, Ignition Coil, 5. Start the engine and allow to idle. 6. Turn the steering wheel to the left and right until there are no air bubbles in the oil reservoir. 7. Confirm that the fluid is not milky, and that the level is between the high and low dipstick marks. 8. Confirm that there is very little change in the fluid level when the steering wheel is turned left and right. AC206743 RETURN VINYL HOSE AB |