Range Rover Sport. Manual - part 69

 

  Index      Land Rover     Range Rover Sport - service repair manual 2005-2009 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  67  68  69  70   ..

 

 

Range Rover Sport. Manual - part 69

 

 

 

Discard the nut.

6 . Remove and discard the O-ring seals and spacer. 

7 . Remove the nylon retaining pin. 

8 . Remove the rebound plate and spring aid.

Remove the air spring.

 

Using a soft faced mallet, gently tap the sleeve support upwards to release it from the O-ring
seals.

 

Remove and discard the 2 O-ring seals.

10 . Remove the shock absorber from the vise.

Installation

1 . Install the shock absorber in the vise.

2 . Clean the components.

3 . Lubricate and install new O-rings to the seal carrier.

4 . Install the spring aid and rebound plate.

5 . Install the air spring.

 

Align the piston with the first O-ring seal, making sure the location tag is correctly aligned.

7 . Install the rubber bushing and rebound washer.

 

Make sure the formed insert on the bushing is located against the O-ring seal.

8 . Install and lightly tighten the nut.

9
.

  CAUTION: The air supply must be free of any moisture.

  CAUTION: If during disassembly the air sleeve is unrolled, the air sleeve may inflate incorrectly (to

one side). If this occurs, release the air pressure, and insert a suitable tool that will not damage the air
sleeve or piston (a screw driver handle), into the side opposite the bulge. Inflate and deflate until the air
sleeve inflates correctly (the air sleeve will be uniform inside the shroud).

Install the air spring piston over the O-ring seals.

 

Using the special tool coupled to a tire inflator with a gauge, apply approximately 2 bar of air
pressure to the air spring to fully seat the piston over the O-ring seals.

10 . Tighten the top nut to 98 Nm (72 lb.ft).

11
.

Check the assembly for leaks.

 

Inflate the module to 4 bar and check for pressure loss.

 

If a leak is suspected, immerse the spring and shock absorber assembly in a tank of water
to locate the source of the leak.

12 . Install the gaiter.

 

Using the special tool, install new straps.

For additional information, refer to 

Rear Shock Absorber and Air Spring Assembly (64.21.01.99)

 

 

 

 

 

 

 

Content   ..  67  68  69  70   ..