TEST
ACTION
APPLICABILITY
4
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Disconnect the Driver Airbag Module.
Disconnect the Clockspring connector.
Disconnect the Passenger Airbag.
Disconnect the Airbag Control Module connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the Airbag System Load Tool 8310 ACM Adaptor to the Airbag Control
Module connector.
Turn Ignition On, then reconnect the Battery.
Measure the voltage at the Driver Airbag Line 1 and Line 2 circuits and then
Passenger Airbag Line 1 and Line 2 circuits at the ACM Adaptor.
Is there any voltage present?
All
Yes
→
Repair Squib Line 1 or Line 2 circuit short to battery.
Perform AIRBAG VERIFICATION TEST - VER 1.
No
→
Replace the Airbag Control Module in accordance with Service
Instructions. WARNING: make sure the battery is disconnected
and wait 2 minutes before proceeding.
Perform AIRBAG VERIFICATION TEST - VER 1.
NOTE: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
28
AIRBAG
EITHER SQUIB TERM SHORT TO BATTERY - ACTIVE —
Continued