Jeep Wrangler TJ. Manual - part 168

 

  Index      Jeep     Jeep Wrangler TJ - service repair manual 2005 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  166  167  168  169   ..

 

 

Jeep Wrangler TJ. Manual - part 168

 

 

TEST

ACTION

APPLICABILITY

7

If there are no possible causes remaining, view repair.

All

Repair

Replace the Transmission Oil Pump per the Service Information.
Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

397

TRANSMISSION - 42RLE

P0944-LOSS OF PRIME —

Continued

Symptom:

P0992- 2-4/OD HYDRAULIC PRESSURE TEST FAILURE

When Monitored and Set Condition:

P0992- 2-4/OD HYDRAULIC PRESSURE TEST FAILURE

When Monitored:

In any forward gear with engine speed above 1000 RPM shortly after

a shift and every minute thereafter.

Set Condition:

After a shift into a forward gear, with engine speed > 1000 RPM, the TCM

momentarily turns on element pressure to the clutch ckts that don’t have pressure to
identify the correct pressure sw closes. If the pressure sw does not close 2 times the code
sets.

POSSIBLE CAUSES

CONDITION P0992 PRESENT

TEST

ACTION

APPLICABILITY

1

NOTE: Low fluid level can be the cause of many Transmission problems. If
the fluid level is low, locate and repair the leak, then check and adjust the
fluid level per the Service Information.
NOTE: Always perform diagnostics with a fully charged battery to avoid
false symptoms.
With the DRBIII

t, read the engine DTC’s. Check and repair all engine DTC’s prior

to performing Transmission Symptom Diagnostics.
With the DRBIII

t, read Transmission DTC’s. Record all DTC’s and 1 Trip Failures.

NOTE: Diagnose 1 Trip Failures as a fully matured DTC.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
Repair as necessary.
Perform the Shift Lever Position Test. If the test does not pass, refer to Symptom test
for P0706 Check Shifter Signal.
For Gear Ratio DTC’s, check and record all CVI’s.
Most DTC’s set on start up but some must be set by driving the vehicle such that all
diagnostic monitors have run.
NOTE: Verify flash level of Transmission Control Module. Some problems
are corrected by software upgrades to the Transmission Control Module.
NOTE: Check for applicable TSB’s related to the symptom.
Perform this procedure prior to Symptom diagnosis.

All

Continue

Go To

2

398

TRANSMISSION - 42RLE

TEST

ACTION

APPLICABILITY

2

NOTE: The vehicle must be driven to set this DTC, the transmission must be
warm or hot with the Engine RPM above 1000 RPM.
This DTC is an indicator of a 2/4 and/or O/D Hydraulic Pressure Switch DTC’s
present. Perform the tests for P0870 and/or P0845 to determine which switch is
failing.
If there are no possible causes remaining, view repair.

All

Repair

Refer to the Transmission category and perform the appropriate
symptom for P0870 and/or P0845.
Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

399

TRANSMISSION - 42RLE

P0992- 2-4/OD HYDRAULIC PRESSURE TEST FAILURE —

Continued

Symptom:

P1652-SERIAL COMMUNICATION LINK MALFUNCTION

When Monitored and Set Condition:

P1652-SERIAL COMMUNICATION LINK MALFUNCTION

When Monitored:

Continuously with engine running.

Set Condition:

The DTC sets in approximately 20 seconds if no BUS messages are

received by the TCM.

POSSIBLE CAUSES

NO COMMUNICATION WITH MIC

NO COMMUNICATION WITH PCM

INTERMITTENT WIRING AND CONNECTORS

TRANSMISSION CONTROL MODULE

TEST

ACTION

APPLICABILITY

1

With the DRBIII

t, erase TCM DTC’s.

Note: Erase P0700 DTC in the PCM to turn the MIL light off after making
transmission repairs.
Start the engine in park.
Did the DTC reset after the engine was started?

All

Yes

→ Go To 2

No

→ Go To 5

2

Ignition on, engine not running.
With the DRBIII

t, attempt communication with the MIC

Can you communicate with the MIC?

All

Yes

→ Go To 3

No

→ Refer to the Communication category for the related symptom(s).

Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

3

Ignition on, engine not running.
With the DRBIII

t, select the following screens in order: 9BODY9 9MIC9 9MONITOR

DISPLAY

9 9PCI BUS ENGINE INFO9.

Does the DRBIII

t, read 9NO RESPONSE9 from any of the listed PCM monitors?

All

Yes

→ Refer to Communication Category for the related symptom(s).

Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

No

→ Go To 4

400

TRANSMISSION - 42RLE

 

 

 

 

 

 

 

Content   ..  166  167  168  169   ..