|
|
Symptom: P0760-OD SOLENOID CIRCUIT When Monitored and Set Condition: P0760-OD SOLENOID CIRCUIT When Monitored: Initially at power-up, then every 10 seconds thereafter. They will also be tested immediately after a Gear Ratio or Pressure Switch error is detected. Set Condition: Three consecutive solenoid continuity test failures, or one failure if test is run in response to a Gear Ratio or Pressure Switch error. POSSIBLE CAUSES RELATED RELAY DTC’S PRESENT INTERMITTENT WIRING AND CONNECTORS TRANSMISSION CONTROL RELAY OUTPUT CIRCUIT OPEN OD SOLENOID CONTROL CIRCUIT OPEN OD SOLENOID CONTROL CIRCUIT SHORT TO GROUND OD SOLENOID CONTROL CIRCUIT SHORT TO VOLTAGE OD SOLENOID TRANSMISSION CONTROL MODULE TEST ACTION APPLICABILITY 1 NOTE: Low fluid level can be the cause of many Transmission problems. If t, read the engine DTC’s. Check and repair all engine DTC’s prior to performing Transmission Symptom Diagnostics. t, read Transmission DTC’s. Record all DTC’s and 1 Trip Failures. NOTE: Diagnose 1 Trip Failures as a fully matured DTC. All Continue 357 TRANSMISSION - 42RLE |