Jaguar X-Type Sedan and Estate (Wagon). Manual - part 596
22. Make sure the rear wiper pivot arm is in the parked position.
23. Open the liftgate window glass.
24. Open the liftgate.
25. Remove the liftgate trim panel.
For additional information, refer to:
Liftgate Trim Panel
(501-05 Interior
Trim and Ornamentation, Removal and Installation).
26. Loosen the rear wiper motor retaining nuts.
27. Close the liftgate.
28. Make sure the liftgate glass latch and rear wiper mounting arm locate
correctly into the liftgate latch actuator and rear wiper motor.
29. Close the liftgate glass.
30. CAUTIONS:
With the aid of an assistant in the loadspace, fully tighten the rear
wiper motor retaining nuts. Failure to follow this instruction may result in
damage to the vehicle.
Make sure the rear wiper motor does not move whilst tightening the
retaining nuts. Failure to follow this instruction may result in damage to
the vehicle.
Tighten the rear wiper motor retaining nuts in the sequence shown.
Tighten to 8 Nm.
31. Visually check the liftgate for correct alignment.
32. Install the liftgate trim panel.
For additional information, refer to:
Liftgate Trim Panel
(501-05 Interior
Trim and Ornamentation, Removal and Installation).