Leaving vehicle with engine running
In case you have to leave your vehicle
with engine running, please confirm the
parking brake has been tensioned and
the neutral gear is engaged before leav鄄
ing.
Anti-lock braking system (ABS)
Anti -lock braking system is an ad鄄
vanced electronic brake system which
helps to prevent vehicle sliding and
out-of-control. This system enables you
to steer clear of obstacle upon hard
braking and provides maximum braking
ability on slipping road surface.
When the ignition switch is connected,
the ABS warning lamp will be on for
about 3s. If the ABS warning lamp is not
off or it's on during driving, it indicates
the ABS is at fault.
Please consult the after service center
specially designated by JAC immedi鄄
ately. Please refer to the 野ABS冶 warn鄄
ing. The ABS system will monitor each
wheel speed during braking. If one
wheel tends to be blocked, the com鄄
puter will control the brakes of the two
front wheels and rear wheels respec鄄
tively. When the ABS is working, the
brake pedal will present slight vibration
accompanied with noise generally.
Though the brake system is equipped
ABS, please don't step the brake pedal
frequently under any road conditions.
Step the brake pedal to the end and
hold it to enable the ABS to work.
-11
Notes
It's very dangerous if you leave the ve鄄
hicle with engine running. If the parking
brake is tensioned while the gear shift
lever is not engaged to neutral gear
completely, the vehicle may move sud鄄
denly. Furthermore, if you don't shut
down the engine after leaving the vehi鄄
cle, it will cause overheating of engine
and even initiate fire get you or other
injured. Please shut down the engine
when you leave the vehicle.
Notes
ABS neither changes the time required
by brake engagement nor shortens the
braking length absolutely. Please keep
sufficient braking length even if your ve鄄
hicle is equipped with ABS.
MO TORS
Parking brake
Parking brake lever is between the front
seats.
To tension the parking brake, please
step the brake pedal and pull the park鄄
ing brake level up. If the ignition switch
is connected, the brake system warning
lamp will be on. See Brake System
Warning Lamp in Chapter 3.
To release the parking brake system,
step the brake pedal and pull the park鄄
ing brake level up until the release but鄄
ton can be pressed. Press the release
button and lower the parking brake
lever to the end at the same time.
1. Step the brake pedal and tension the
parking brake.
2. Engage the neutral gear.
3. Turn the ignition key to LOCK position.
4. Pull the key out and carry it by your鄄
self.
Friendly Tips
Don't drive your vehicle with parking
brake not released, otherwise it will re鄄
sult in brake system overheating and
cause undue abrasion or damage of
brake system parts. Check whether the
parking brake is completely released
and the brake warning lamp is off be鄄
fore driving.
Notes
It's very dangerous to get off the vehi鄄
cle when the parking brake is applied
while the gear shift lever is not en鄄
gaged to parking gear, since the vehi鄄
cle may move suddenly. If you leave
the vehicle with engine running, the
vehicle may move suddenly, which may
result in injury of you or others. To pre鄄
vent the vehicle moving, please ob鄄
serve the following procedures even if
the vehicle is on flat road surface.
-10
Nentral