|
|
|
WINDSHIELD WIPER/WASHER: VARIABLE INTERMITTENT
(Refer to Section 201 for photographs.)
Component
Photo No.
Alarm and Relay Control Unit
Behind right side of I/P, above kick panel
78
. .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Dash Fuse Box
Left side of I/P, behind panel
58
. . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Windshield Washer Motor
Right front corner of engine compartment, in washer fluid reservoir
25
. . . .
. . . . . . . . . . .
Windshield Wiper Motor
Right rear corner of engine compartment, on bulkhead
9
. . . . . .
. . . . . . . . . . . . . . . . . . . . . . .
Connector
C-27 (6-WHT)
Right rear corner of engine compartment, on wiper motor assembly
9
. . . . . . . . . . . . . .
. . . . . . . . . . . .
H-13 (16-WHT) (2.2L)
Below right side of I/P, behind kick panel
82
. . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
H-13 (20-WHT) (3.2L)
Below right side of I/P, behind kick panel
82
. . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
I-31 (13-WHT)
Behind left side of I/P, on connector bracket
67
. . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ground
B-7
Below center console
81
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
C-16
Left rear corner of engine compartment, on inner fender panel
43
. . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . .
C-36
Right side of engine compartment, behind battery
13
. . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
P-6
Right side of engine compartment, behind battery
13
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
Component Location Index
With the starter switch in ON or
START, battery voltage
is applied through the CB-17 FRONT WIPER & WASH-
ER fuse to the windshield wiper/washer switch, wind-
shield wiper motor, and alarm and relay control unit.
Low Speed
When the windshield wiper switch is moved to LO,
battery voltage is applied to the LO winding of the
windshield wiper motor and the windshield wipers run
at low speed.
Park/Run
When the windshield wiper switch is turned to OFF, the
CB-17 fuse provides battery voltage through the wind-
shield wiper motor, alarm and relay control unit, and the
windshield wiper switch to the LO winding of the wind-
shield wiper motor. When the switch on the motor
reaches the PARK position, battery voltage from the
CB-17 FRONT WIPER & WASHER fuse is removed
from the circuit and the windshield wipers stop in the
PARK position.
High Speed
When the windshield wiper switch is in HI, battery volt-
age is applied to the HI winding of the windshield wiper
motor and the windshield wipers run at high speed.
Intermittent
When the windshield wiper switch is moved to INT, the
windshield switch applies battery voltage to the alarm
and relay control unit. The alarm and relay control unit
momentarily energizes and applies battery voltage to
the LO winding of the windshield wiper motor to move
the windshield wipers from the PARK position to the
RUN position. Then, the PARK/RUN function takes
over to return the windshield wipers to the PARK posi-
tion. The windshield wipers make a single sweep as de-
termined by the alarm and relay control unit. The alarm
and relay control unit determines the amount of delay
by sensing a voltage drop across the variable intermit-
tent input.
Washer
When the windshield washer switch is moved to
WASH, battery voltage is applied to the windshield
washer motor and the alarm and relay control unit. The
windshield washer motor pumps fluid on the wind-
shield, and the alarm and relay control unit energizes
and applies battery voltage to the LO winding of the
windshield wiper motor through the windshield wiper
switch. The wipers run at LO speed for three to four
sweeps after the switch is released.
Circuit Operation
91Ć2
REAR WIPER/WASHER
Alarm and Relay Control Unit
Rodeo
Rodeo Sport
Dash Fuse Box
Rodeo
Rodeo Sport
Hatch Gate Open Switch
Rear Washer Motor
Rodeo
Rodeo Sport
Rear Wiper Motor
Rodeo
Rodeo Sport
Rear Wiper Switch
Rodeo
Rodeo Sport
Tailgate Open Switch
Component Index
92
REAR WIPER/WASHER: RODEO
CB-16
(REAR
WIPER &
WASHER)
10A
8
LT GRN/BLK
DASH
FUSE
BOX
LT GRN/BLK
HOT IN ON
I-17
Connector
6
9
GRN/RED
LT GRN/BLK
REAR
WIPER
SWITCH
ILLUMINATION
7
I-17
Connector
10
REAR
WIPER
MOTOR
19
I-42
Connector
20
Dash and Console Lights
Page 117
YEL/RED
LT GRN/WHT
RED/GRN
YEL/GRN
8
YEL/GRN
2
17
YEL/GRN
GRN/RED
5
GRN/RED
I-42
Connector
13
1
GRN/RED
LT GRN/BLU
2
LT GRN/BLU
5
16
LT GRN/BLU
BRN/WHT
H-22
Connector
7
BRN/WHT
I-41
Connector
12
H-31
Connector
18
BRN/WHT
LT GRN/BLK
3
GRN/BLK
6
*15
M
WASHER
WIPER
Washer
ON input
Wiper
ON input
Wiper motor
control
GRN
1
YEL
2
RED
4
BLK
G-6
Connector
6
BLU
5
RUN
PARK
See Dash
Fuse Box,
page 11-7.
LT GRN/BLK
H-32
Connector
11
(Not used)
4
Ignition
GRN/YEL
H-19
Connector
Switched +/–
* =
With Sound System Amplifier
LT GRN/BLK
SWITCH
UNIT B
Circuit Schematic
92-1
REAR WIPER/WASHER: RODEO
RED/WHT
I-42
Connector
8
See Ground
Distribution,
page 14-3.
C-36/P-6
BLK
BLK
H-31
Connector
2
LT GRN
LT GRN
M
H-13
Connector
10
LT GRN/WHT
BLK
I-41
Connector
4
LT GRN/WHT
C-30
Connector
1
C-30
Connector
2
Courtesy Lights
Page 114-1
Keyless Entry and
Anti-theft System
Page 133-1
LT GRN
H-22
Connector
6
LT GRN
I-42
Connector
17
REAR
WASHER
MOTOR
HATCH GATE
OPEN SWITCH
Closed with
hatch gate open.
ALARM
and RELAY
CONTROL
UNIT
Solid State:
Do not check
resistance.
Rear
washer
control
Hatch
“open”
input
G-1
Connector
1
H-22
Connector
1
See Ground
Distribution,
page 14-2.
B-7
BLK
BLK
BLK
BLK
G-1
Connector
2
BLU
BLK
CB-5
DOME
LIGHT
10A
RED/WHT
DASH
FUSE
BOX
HOT AT ALL TIMES
RED/WHT
I-41
Connector
11
Battery
LT GRN/BLK
6
Ignition
See Dash
Fuse Box,
page 11.
Circuit Schematic
|
|
|