|
|
|
TM-118 < ECU DIAGNOSIS > TCM Even when the electronic circuits are normal, under special conditions (for example, when slamming on the brake with the wheels spinning drastically and stopping the tire rotation), the transmission can go into fail-safe mode. If this happens, switch “OFF” the ignition switch for 10 seconds, then switch it “ON” again to return to the normal shift pattern. Therefore, the customer's vehicle has returned to normal, so handle according to the “diagnostics flow” (Refer to FAIL-SAFE FUNCTION If any malfunction occurs in a sensor or solenoid, this function controls the A/T to mark driving possible. Output Speed Sensor • Signals are input from two systems - from output speed sensor installed on the transmission and from com- bination meter so normal driving is possible even if there is a malfunction in one of the systems. And if output speed sensor has unusual cases, 5GR is prohibited. Accelerator Pedal Position Sensor • If there is a malfunction in one of the systems, the accelerator opening angle is controlled by ECM according to a pre-determined accelerator angle to make driving possible. And if there are malfunctions in tow sys- tems, the engine speed is fixed by ECM to a pre-determined engine speed to make driving possible. Throttle Position Sensor • If there is a malfunction in one of the systems, the accelerator opening angle is controlled by ECM according to a pre-determined accelerator angle to make driving possible. And if there are malfunctions in tow sys- tems, the accelerator opening angle is controlled by the idle signal sent from the ECM which is based on input indicating either idle condition or off-idle condition (pre-determined accelerator opening) in order to make driving possible. Transmission Range Switch • In the unlikely event that a malfunction signal enters the TCM, the position indicator is switched “OFF”, the starter relay is switched “OFF” (starter starting is disabled), the back-up lamp relay switched “OFF” (back-up lamp is OFF) and the position is fixed to the “D” position to make driving possible. Starter Relay • The starter relay is switched “OFF”. (Starter starting is disabled.) Interlock • If there is an interlock judgment malfunction, the transmission is fixed in 2GR to make driving possible. NOTE: When the vehicle is driven fixed in 2GR, a input speed sensor malfunction is displayed, but this is not a input speed sensor malfunction. • When the interlock is detected at the 3GR or more, it is locked at the 2GR. 1st Engine Braking • When there is an 1st engine brake judgment malfunction, the low coast brake solenoid is switched “OFF” to avoid the engine brake operation. Line Pressure Solenoid • The solenoid is switched “OFF” and the line pressure is set to the maximum hydraulic pressure to make driv- ing possible. Torque Converter Clutch Solenoid • The solenoid is switched “OFF” to release the lock-up. Low Coast Brake Solenoid • When a (electrical or functional) malfunction occurs, in order to make driving possible, the engine brake is not applied in 1GR and 2GR. Input Clutch Solenoid • If a (electrical or functional) malfunction occurs with the solenoid either “ON” or “OFF”, the transmission is held in 4GR to make driving possible. Direct Clutch Solenoid • If a (electrical or functional) malfunction occurs with the solenoid either “ON” or “OFF”, the transmission is held in 4GR to make driving possible. Front Brake Solenoid • If a (electrical or functional) malfunction occurs with the solenoid “ON”, in order to make driving possible, the A/T is held in 5GR; if the solenoid is OFF, 4GR. |